Part Number: TLV8801 Other Parts Discussed in Thread: OPA336 ,
HI
I can find rail to rail out spec in OPA336
But I can't find the rail to rail information in TLV8801
Part Number: LPV542 Other Parts Discussed in Thread: OPA336 , , TINA-TI I'm using this op-amp to integrate a very small photocurrent. The signal ramps up for about 40ms. C3 holds the integrated signal until U3 (analog switch) resets the integral, and…
Part Number: XTR117 Other Parts Discussed in Thread: LM2902 , TLV9001 , LMV321A , , OPA392 , OPA391 , OPA336 , OPA396 Hi Team,
I am using XTR117AIDGKR as a current transmitter(4-20mA) for a position transmitter.
So kindly verify and let me know your…
HI Conrad,
The OPA4340 with the 33-ohm and 10nF will work well. (EDIT: Updated simulations with 33-ohm and 10nF below)
Below is the closed loop DC and AC TINA-TI frequency sweep, as well as the open-loop AC stability analysis.
OPA4340 Closed Loop…
Hi Hans,
We have two ultra low Vos op amp that may or may not meet your design requirements. I do not see anything lower than +/-1uV in Vos specification. The published Vos is rated a specific power supply voltages, Vcm, temperature etc.. Your application…
Hi Florian,
• Start with page 2 of the ADS1204 datasheet where you see that AVdd and BVdd are specified WRT AGND and BGND - this tells you they can ramp in
any order and are not related to each other with exception to the AGND and BGND levels. The…
Shibin,
The small signal bandwidth is a function of a close-loop Gain: BW=GBW/Gain. Thus, in Gain=10, OPA336 small-signal bandwidth is just 10kHz (100kHz/10) - please review TI precision lab training material under following link: https://training.ti…
Actually I downloaded right from the TI web page for OPA336.
However, this is not as important now. Please give me some advice on convergence issue with UCCx318-1 model?
I tried different Integration Methods such as Trapezodial, Gear, Modified trap…
Part Number: OPA314 Other Parts Discussed in Thread: OPA336 , LMP7721 Hello TI,
would it be possible to get the datasheet of OPA314 updated (or the underlying data) such that the input bias and offset current plots (figure 14) have a logarithmic current…
Hi Vincent,
I am attaching the schematic from the datasheet for reference:
Using a shielded cable helps to significantly reduce the noise that will couple into your signal chain from the probes, however there is still parasitic capacitance between…
