Part Number: OPT3101-SDK Other Parts Discussed in Thread: OPT3101 , MSP430F5529 Hi,
I am trying to use the OPT3101 SDK to perform full calibration on a few OPTs.
As advised, I am using compiler version 18.12.8 LTS.
But I get these errors:
Building file…
Pengsheng,
You need to do the calibration with the HDR mode turned off. In order to go back to operating mode with longer range you need to turn HDR back on.
Part Number: OPT3101-SDK Other Parts Discussed in Thread: OPT3101 Hello,
I had a problem with Illum Crosstalk : Without masking photodiode ,why do I always get 0.0 when Performing Illum Crosstalk?
I'm checking the SDK source code but can't find the reason…
Part Number: OPT3101 Hi ti Team,
I have a few questions when using OPT3101: 1. There are two grounding examples in the zhcu659a document of TI official website, the difference is that the TX part VSSL is grounded separately, which performance is better…
Part Number: OPT3101 I'm testing OPT3101 mounted on my hardware: I performed step 2 of SDK Calibration and I found that I changes linearly but Q not.
The circuit uses a LTE-C9506B as IR LED and a TEM1000 as photodiode.
Best Regards
Roberto Cerati
Cherry,
The SDK is the closest to an automated calibration you can get. I wasnt sure if the customer was using the SDK or trying to do the calibration manually. It looks like they are doing the calibration using the right tools.
Is the customer still…
Part Number: OPT3101 Hi,
One customer used OPT301 and when he turns off phase calibration, measuring the phase offset, after configuring to phase_offset register, enabling phase calibration at a single frequency read phase, it is correct at 10M frequency…
Part Number: OPT3101-SDK Other Parts Discussed in Thread: OPT3101EVM , OPT3101 Hi Team,
Using the OPT3101EVM with the MSP430F5529LP hardware, open the INLAB_step_1 condition in the SDK to compile.
The calibration distance parameters are not modified and…
Part Number: OPT3101-SDK Hello TI
I have some questions about temperature crosstalk compensation and temperature phase offset compensation.
I have carried out the process following the guidelines in the SDK manual When I calculate my coefficients and enter…
It's clear now. About your questions * I only use one transmitter and one TX0 channel. * Regarding elevation, you mean placing a division between the sender and receiver. I use the same concept as the EVM, I have an Isolation ring and LED HOLDER on the…