Part Number: OPT3101EVM Other Parts Discussed in Thread: OPT3101 Tool/software: I hope this message finds you well.
I am currently working on a project that involves monitoring the interior of industrial ladles, where the temperature can reach up to 600…
Part Number: OPT3101EVM Other Parts Discussed in Thread: OPT3101 Tool/software: I need to sync the OPT3101EVM measurements with another device on MATLAB.
What is the best and easiest way to do connect the OPT3101EVM to Matlab?
What acquisition card …
Pengsheng,
SDK does not write/load the system level coefficients to EEPROM because these values should not change across devices so won't need to change values in OPT3101Coefficients.cpp when loading firmware to a different unit.
The EEPROM is read…
Part Number: OPT3101EVM Hi,
from
<www.ti.com/.../OPT3101EVM
go to OPT3101EVM -> Order from Distributor.
It appears that both links to distributors for the EVM point to wrong products (and list the wrong stock).
Just to confirm, the EVB is not obsolete…
Peter,
There are two ways we can set monoshot mode in OPT3101. Both require that J17 pin-7 must be pulled up to 3.3V.
External
J17 pin-7 ( VSYNC_RST ), give an active low pulse (pulse width range min = 0.1us and max = 1us)
You can verify from dev.frame_count1…
Part Number: OPT3101EVM Other Parts Discussed in Thread: OPT3101 Hi Team,
1) OPT3101EVM is used with MSP430F5529LP connection and provides SDK libraries. After turning on the INLAB_step_0 burn, which of the data output in TeraTerm software is the raw crosstalk…
Part Number: OPT3101EVM Other Parts Discussed in Thread: OPT3101 Consider this a fun - if only slightly oddball - question.
If the OPT3101 is being used as a gestural user input device (i.e. waving your hand), is calibration necessary?
The analogy is a…
Part Number: OPT3101EVM Our preferred use case for the OPT3101EVM would be to capture the data stream directly over the USB port. Reading the documentation, it appears that's what the Latte-based GUI uses. Is it possible to capture the data from the…
Part Number: OPT3101EVM Hello,
We are is only able to get 2-3M of range of the OPT3101EVM kit. Is there something we need to do to get the 10M range?
We are also seeing very narrow FOV.
Thanks!
Part Number: OPT3101EVM Other Parts Discussed in Thread: OPT3101 Hi Experts,
Our customer has a concern as shown:
"We are working on a project with an OPT3101EVM, to test the EVM we are using latte. Using LongDistance mode, 128 sub-frames, and pointing…