Part Number: PCM2707EVM-U Other Parts Discussed in Thread: PCM2906B , PCM2706 , PCM2903C “Could you please recommend a USB audio solution based on the architecture shown in the attached diagram?”
Part Number: PCM2707EVM-U Greetings,
I would like to determine if the I2S bit clock ( BCK ) signal generated by this part is continuous or discontinuous ( burst ).
Thanks and rgds, David
Part Number: PCM2707EVM-U Other Parts Discussed in Thread: PCM2906C Hi Ti Team
I am using it connected to my mobile phone, but noise occurs in the following situations. - When connected to a smartphone: wind blowing sound - When disconnecting from…
Part Number: PCM2707EVM-U Hi, TI expert.
The customer said that there is a problem with the pop up noise of the USB Audio IC (DAC with USB) and wants to review a replacement product. - Existing Part: PCM2707CPJTR
- Request: Products with On/Off Noise…
Part Number: PCM2707EVM-U Other Parts Discussed in Thread: PCM2706C , PCM2704C , HID2 Hello
I have PCM2707EVM-U and I want to develop a board with HID buttons.
I have read the datasheet for PCM270xC and my conclusion is:
1. PCM2707C does not have…
Part Number: PCM2707EVM-U My objective is to build a audio usb device for VoIP application. My requirement if of only two buttons which can provide function of previous track and next track. For that i want to customize the EVM schematics. Is it possible…
Part Number: PCM2707EVM-U Dear all,
I have purchased the PCM2707EVM kit recently.
My objective is to build a audio usb device for self service machines but I am new to usb audio.
Therefore I have two questions:
1) HID control.
Is there any…
Hi Peter, what is VBUS pin (top left) connected to ? It goes to HOST but I can not see the wire labeled VBUS in your schematic.
I also attached the user guide's for your future reference.
Can you tell me if it is possible to check your design with…
Hi, Hanns,
This reminded me of an older post I remember where someone had the same problem, and it was due to a crappy crystal. Well, I found the post, and was a little surprised... :)
I assume you've already tried swapping out the crystal, right…
