Part Number: PCM3060 Other Parts Discussed in Thread: TIDA-060021 Tool/software: Hi, I'm working on an audio design using the PCM3060 and I have a question regarding the output stage—specifically about output gain and low-pass filter component calculations…
Part Number: PCM3060 Tool/software: Hi,
I am working on an audio design using the PCM3060 and I have a question regarding the output stage—specifically about output gain and low-pass filter component calculations. I couldn’t find clear guidelines or…
Part Number: PCM3060 Good morning, I need assistance in selecting an audio codec for my Banana Pi M2 Zero. I want to connect a microphone and a speaker, but my Banana Pi does not have integrated ADC or DAC. I am looking for an audio codec that can read…
Part Number: PCM3060 Hello, I’m working on a laser absorbtion spectrometer. I did a HAT with a pcm3060 to generate a current ramp for driving the laser with its dac. The detectors voltage I plan to evaluate with the adc. I sort of „abuse“ this codec for…
Part Number: TAC5242 Other Parts Discussed in Thread: PCM3060 Tool/software: I'm working on migrating a design from PCM3060 to TAC5242. The design we have is single ended input and single ended output. On the PCM3060, we convert the output from the converter…
Part Number: PCM3060 Hi team,
I thought that when an external reset was applied, Internal Reset would return at the timing when the RST pin went HIGH and the DOUT delay would start from there, but when I actually operated it, DOUT was output as soon…
Part Number: PCM3060
Tool/software:
Hi Experts,
We have question about the capability of PCM3060, the datasheet says it has a stereo input. However, how does the chip handle a mono signal input?
Found this post - TPA 3116 Mono Mode (PBTL) - Audio…
Part Number: PCM3060 I would like to see a block diagram of the analog input circuit.
The figure below shows the expected circuit of the internal block.
If it is expected circuit 1, an ADC input will be offset to the negative side. I think it is not…
Part Number: PCM3060 Other Parts Discussed in Thread: PCM1804 Hi,
I asked a similar question on another device.
Will the answer be the same for PCM3060?
Answer for PCM1804 > A maximum Jitter of 0.5% SCKI would be acceptable. >For 24Mhz this is 200ps…
Part Number: PCM3060 I'm using PCM3060PWR in an audio system, I found it output too much noise.
FIG.1
I play a silence audio file, DAC in PCM3060 output like FIG.1. Then I tie TXD0 to GND, DAC in PCM3060 output also like FIG.1. 5V ripple is in FIG…
