Part Number: PCM5142EVM-U Hi,
A customer purchased a PCM5142EVM-U. When he would use it on PPS(Home Audio), an error message appeared on PC screen, as below.
However, he checked that the device driver of PCM5142EVM-U had been installed normally…
Part Number: PCM5142EVM-U Other Parts Discussed in Thread: PCM5142
Hello
I am tring to use PCM5142EVM-U as following step
1) Connect USB cable
2) recognize USB-Audio EVM
3) Run " Codec Control" slac493a
4) Communication OK
5) check Optical…
Part Number: PCM5142EVM-U Other Parts Discussed in Thread: TLV320AIC3262EVM-U , TLV320AIC3254EVM-K , PCM5141 Hi,
A customer asks to us about an error message of PurePath Studio(Home Audio) using PCM5142EVM-U. The error message is as follows;
Error…
I don't think it needs any specific firmware , I know if you use the EVM, then you need to download the latest TAS1020 USB firmware from the PCM5122EVM-U or PCM5142EVM-U product pages.
The power supply and analog pins can be configured as they are shown in the PCM5142EVM schematic. That is static for all configuration. The digital IO pins depend on the requirements of the system, for example, if you are attenuating the output, using…
Part Number: PCM5122EVM-U Other Parts Discussed in Thread: PCM5121 , , PCM5142EVM-U Dear Sirs,
I have a question.
I will using PCM5121.
But there is not PCM5121EVM. There is PCM5122EVM-U.
So I checked useguide for PCM5122EVM-U and PCM5142EVM-U…
Dear Mr Melendez
Thank you for your answer, and sorry the delay of my reply.
I had tested the frequency responce of PCM5142EVM-U with GDE, and result was as well as PCM5102A.
Thank you and with my best regards
Hi Michael,
The latest version of PPS is 5.95.35815 but I assume the version you are running should work w PCM5142 EVM as well.
Have you made sure the TAS1020 has the latest FW? Please use the link below to download the same:
http://www.ti.com/tool…
Other Parts Discussed in Thread: PCM5142 Dear Justin, Thank you very much for the reply. We have received a PCM5142EVM-U REV B board We are trying to connect to the EVM using Purepath studio via USB. I have selected PCM5120_USB_ROM.pfw The jumper selections…
