Hi Daveon
Adjusting the "ground capacitance" and "ground capacitance" of INxP and INxM will help the resistance of MICBIAS. Currently, when adjusting the channel Gain, the recorded signals can be received. Thank you for your help. …
Part Number: PCM6260-Q1 Hi Expert,
My customer would like to test SNR, THD+N, Dynamic range parameters on their PCB level with PCM6260-Q1.
May you kindly share some guidelines for these tests? And I also wonder that how can we measure the output signal…
Part Number: PCM6260-Q1 Hi expert,
Could you please help review the schematic for PCM6260QRTVRQ1?
I'm sorry I could not attach the schematic in this threat because the customer's logo is in the page.
Please send my your mail, I'll send it to you…
Part Number: PCM6260-Q1 hi team,
now customer set up the PCM6260-q1, but First slot of TDM exception from PCM6260 output.
test condition:
VBIAS: 8 V
D3V3_2: 3.36 V
VBAT_FILTER: 12 V
The start timing is as follows: 1 Power up 2.DSP provides BCLK and SYNC to…
Part Number: PCM6260-Q1 Hi team,
One question would like to check with you. One of the input to PCM6260 is the AC differential signal(0~3.3V). Below is the schematic for PCM6260. You can find the AC input portion(SPK+, SPK-) in the red box.
I would like…
Part Number: PCM6260-Q1 Hello,
we are planning to use this PCM6260QRTVRQ1 IC for Audio ADC over I2s interface, pleases let us know where is the linux driver source available for this.
Part Number: PCM6260-Q1 Other Parts Discussed in Thread: PUREPATHCONSOLE Hi
The customer's board currently has two PCM6260s installed. GPIO1 has been connected to a GPIO interrupt. But no matter how you adjust the register setting value of the bin…
Part Number: PCM6260-Q1 Hi
Can you give some suggestions to customers about the problems that occur when PCM6260 is re-ported? After adding &mcasp0 in DTS, there will be an error. The board we match is NXP imx8mp Do you have any information about…
Part Number: PCM6260-Q1 Hi team,
My customer wants to know if there's any potential risk when the MIC+ input line is shorted to the battery (12V), higher than the specified V_MICBIAS = 9V. The customer is currently using the DC-Coupled Microphone Differential…