I would like to power the core for a very large FPGA with the PTH08T220Wxx. I plan to use TPME687M006R0023 (680uF, tantalum, 23mohms) based on the recommended decoupling for the FPGA. I would like to use 7 of these caps which falls below the 5000uF max…
Other Parts Discussed in Thread: PTH08T220W I have a 12v source as an input to PTH08T220W to create a 5v supply.
I am planning on using the 5v as an input to another PTH08T220W to create a 3.3V supply. Also, I am planning on using the 5V as an input…
Other Parts Discussed in Thread: PTH08T220W Hi,
I would like to know the operating temperature of the big inductor (please provide me the manufacturer part number if it is possible) on module PTH08T220W. In the system that I worked on, there is no air…
Other Parts Discussed in Thread: PTH08T220W hI,
i am using PTH08T220W for 3.3 Volt. i am getting lot of hissing noise. and i observed that the transformer on module heating up. i have cheked with load and withoul load also. please suggest. for refrence…
Other Parts Discussed in Thread: PTH08T220W I'm seeing worst than expected transient response with PTH08T220W and type B bulk capacitors. After reviewing the spec, I'm wondering if I have the optimum turbotrans resistor value. I have a 470uF cap with…
Other Parts Discussed in Thread: PTH08T220W Hi,
Will the PTH08T220W be ok if voltage is applied to its output from a bench supply when the device is disabled?
If not, what circuitry is required for protection/isolation?
Thanks very much for all…
Part Number: PTH08T230W Other Parts Discussed in Thread: PTH08T220W , TPS40100 Tool/software: Hi,
We are utilizing the PTH08T230W power module, which is set to output 0.8V. When we measure the voltage at test point TP9, which is situated close to the…
Other Parts Discussed in Thread: PTH08T220W Hallo,
i have to design a powersupply for a VIRTEX7 MGTAVCC 1.0V
The VIRTEX Power Estimator give me a result of 13A for our design.
In the XILINX datasheet the Ripple of the MGTAVCC must less then 10mVpp…
