Part Number: PTH08T230W Tool/software: Hi,
We are using the PTH08T230W power module and performing output voltage margining with the LTC2970. Are there any limitations of the PTH08T230W regarding voltage margining? There is a discussion thread addressing…
Part Number: PTH08T230W AS WE PURCHASED THIS PART WITH WITH ORDER NO T02165987 WE PURCHASED AROUND 62 NOS WE HAVE ASSEMBLED THIS PART INTO SOME OTHER BOARDS WE OBSERVED THAT IN SOME BOARDS THERE IS A NOISE LIKE SOUND IT IS ONLY FOR SOME MODULES NOT FOR…
Part Number: PTH08T230W Hi :
I have two PTH08T230W output is 0 V. I tested the resistance between the bad module and the good module, and found no abnormality. Is there any suggestion to test the module? Thank you very much.
Part Number: PTH08T230W We use 8 of the PTH08T230W on a board we designed and have been shipping for a couple of years.
We recently had a number come back because some or all of the parts failed.
After a root cause analysis, a growth was discovered on…
Other Parts Discussed in Thread: PTH08T240W , PTH08T210W , PTH08T230W Hi,
We would like to find the correct Rtt for C0 values in our PTH08T210W, PTH08T240W and PTH08T230W design.
In the datasheet, the Co is the total output capacitance. Is that means, Co…
Other Parts Discussed in Thread: PTH08T230W According to the datasheet, when the output voltage(Vo) of PTH08T230W is set to 1.0V, the maximum input voltage is VoX11, so the maximum input voltage is 11V. But in sltu003, the input voltage is 12V. I want to…
Other Parts Discussed in Thread: PTH08T230W Hi,
I used the PTH08T230W to power motherboard with FPGA VIRTEX5.
I use 4 PTH08T230W modules. the modules set to 3.3v, 2.5v, 1.8v and 1.0v.
A daughter card is connected to the motherboard through board to…
Other Parts Discussed in Thread: PTH08T260W , PTH08T230W PTH08T260W is rated 3A. It can handle it at 85°C with convection only.
Its overcurrent threshold is 5.5A (typical, no min nor max stated).
We would load this module with up to 3.5A. I suspect…
