Part Number: PTN78000W Tool/software: Hi TI,
I'm writing to seek technical advise on processing MPN: PTN78000WAH by wave soldering.
As you know, lead shoulder standoff has diameter 70 mil is blocking the PTH hole (57 mil) at the solder destination…
Part Number: PTN78000W Hi,
on the web page " ">www.ti.com/.../PTN78000W" , I installed PSpice-Ti but there is no model in the library. can you help me ?
Part Number: PTN78000W Could you tell me whether this part corresponds to 8g (i) or 8g (ii) of ELV described in the following document?
www.ti.com/.../szzq125
Part Number: PTN78000W Hi Team,
Our customer would like to confirm if they can use the PTN78000WAZ on the board designed for PTN78000WAH. Please see the details of his inquiry below.
We have some SMT parts, PTN78000WAZ, otherwise identical to…
Part Number: PTN78000W Tolerances specified in the datasheet of PTN78000W.
what is Set-point voltage tolerance (±2%)?
what is the tolerance of error amplifier?
Total output voltage variation (±3%): it stated the test condition including set…
Part Number: PTN78000W Hi Team,
the datasheet specifies PTN78000WAS being non-ROHS, however both Mouser and Farnell list as ROHS and provide compliance certificates.
Please could you clarify what the ROHS status is?
Thanks and best regards,
A…
Part Number: PTN78000W Hello Team,
Need the dimension details of the Solder Pins used in PTN78000WAZ.
When I refer in the PTN78000WAZ Spec Sheet, It was mentioned to refer the Solder Pins Datasheet for further details. But the datasheet of the…
Part Number: PTN78000W Hi,
what are the acceptable voltage ranges on pin4 of the PTN78000W?
Is there a drawing showing how this is derived?
Is the Rp a top resistor for the feedback network and there is a Vfb of 2.5V?
Thank you!
-Alberto
