Search tips
Showing 20 results View by: Thread Post Sort by

  • REF3012: IBIS model

    TI Thinks Resolved
    Part Number: REF3012 Hello Team, Do we have IBIS model for this part? Regards, Renan
    • Answered

  • REF3012: REF3012

    Resolved
    Part Number: REF3012 Is the part CMOS or bipolar Is the part susceptible to latchup
    • Resolved
    • Answered

  • REF3012: REF3012 IBIS model behavior

    Resolved
    Part Number: REF3012 Hi Experts, We are running REF3012 IBIS model. We are assuming to use 10mA load current so add 125 ohm register as shown in below. VOUT becomes 104.86uV. We expected not large dropout which is shown on the datasheet. Could you please…
    • Resolved
    • Answered

  • REF3012: REF3012 Minimum voltage spec (under limitted output condition)

    Resolved
    Part Number: REF3012 I would like to use REF3012 with VIN=1.8V. I found an answer "It is ok if it is slightly lower than 1.8V. The only time 1.8V comes into effect is if the device is sourcing its max current." in the thread 'REF3012: Minimum…
    • Resolved

  • REF3012: a resistor in series with output cap is required for better noise performance?

    TI Thinks Resolved
    Part Number: REF3012 Other Parts Discussed in Thread: REF5050 Hi team, For better noise performance, a resistor in series with output capacitor can be added as option in some of your products like REF50xx. Does the resistor in case of REF3012 also help…
    • Answered

  • REF3012: REF3012 rad

    Resolved
    Part Number: REF3012 Hi, Did this part pass electrical latch up testing? Do you have radiation data? munir

  • REF3012: regulation questions

    Part Number: REF3012 Other Parts Discussed in Thread: REF3025 Customer found when no load, the output voltage of REF3012 and REF3025 are too high and violate the spec in the datasheet. please find the measured values here. Could you explain why the behavior…
    • Answered

  • ADS1262: TI REF3012 vs TI INA125: Who is the best for my ADS1262

    Resolved
    Part Number: ADS1262 Other Parts Discussed in Thread: REF3012 , INA125 , ADS1235 , OPA388 , ADS1261 Hello people! With ADS1262 PGA set on Gain 32, the full scale is 78mV, so my load cell -with its 20mV max output- isn't able to exploit ADS capabilities.…
    • Resolved

  • REF3012: Max Power

    TI Thinks Resolved
    Part Number: REF3012 I was wondering what the maximum power for this voltage regulator is. Thank you!
    • Answered

  • REF3012: by pass capacitor

    Resolved
    Part Number: REF3012 Other Parts Discussed in Thread: INA333 I will use REF3012 to provide a constant voltage (500mV) input to INA333 (VIN-). The data sheet for REF30xx ( www.ti.com/.../ref3012.pdf) showed that, in Figure 29, a 0.47uF by-pass capacitor…
    • Resolved

Didn't find what you are looking for? Post a new question.