Part Number: REF4132 Other Parts Discussed in Thread: LM4120 , , REF2025 Tool/software: REF4132B25DBVR load capacitance is higher than for LM4120
The higher capacitance requirement appears to be for stability of the output.
If the load is lower than maximum…
Part Number: REF4132 Other Parts Discussed in Thread: LM4132 , Tool/software: Re: e2e.ti.com/.../lm4132-no-connect-pin-1
Another forum poster was recommended to use REF4132 instead of LM4132 because "you can connect Pin 1 to GND". I have checked…
Part Number: REF4132-Q1 How to calibrate the temp drift? And in the design tool, the calibration is about the temp?
Can you help to show how to calibrate about REF4132-Q1? Thanks in advance.
Part Number: REF4132 Other Parts Discussed in Thread: LM4120 , REF35 Requesting verification of Noise Levels between LM4120AIM5-2.5/NOPB and the TI recommended replacement of REF4132B25DBVR. Data sheets use different references.
LM4120AIM5-2.5/NOPB:
REF4132B25DBVR…
Part Number: REF4132 Other Parts Discussed in Thread: LM4120 ,
Hi Team
Could you please tell me the wire number of REF4132B33DBVR and LM4120AIM5X-3.3/NOPB if you can share in this page?
Best regards,
Kenta
Hi Wang,
Just for clarify here, are we referring to the REF4132B25DBVRQ1 or REF4132B25D ? As this is a BMS application I am assuming the automotive grade device will be used.
wang nanhan said: 1. is this OK to get high accuracy for trigger? <1% all condition…
Part Number: REF4132 Hi All,
I have a question about REF4132.
If VIN has already been input, I think that it is possible to input to EN with resistive voltage division. is my understanding correct?
Also, according to the data sheet below, the rise of…
Part Number: REF4132-Q1 Hello. I am looking for a suitable second source for our design. In this circuit, the REF4132A40DBVRQ1 (reference 4.096V) is the EN pin to enable the output. Can this pin be left unconnected? Does it have an internal pull up/down…
