Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: REF6025 Other Parts Discussed in Thread: ADS8887 , , ADS8881EVMV2-PDK , ADS8881 , REF6045 Tool/software: I am using the REF6025 and ADS8887 in a design, with the REF6024.
The datasheet for the REF60xx series, on page 23, in section 9.3.4 Stabilitypage…
Part Number: REF6025 Hi,
I'm looking to use the REF6025 and was looking at the SS pin to maximize the current.
On the pin configuration and functions section it says "Connect to Vin pin for highest current limit", is this a short connecting SS to…
Hi Keith,
Thank you. Yes, I have designed in one REF5025 / ADS1278, but I did not know the REF5025 could not supply the pulses of current quickly enough. I am tight on board area, so the REF6025 is an interesting idea, although I see the output is rated…
Part Number: REF6025 Hello,
Our customer has a question for REF60xx. There is Figure 17 and 18 (see below) for load transient response in the datasheet(SBOS708B). What is C_L value for these graphs?
Regards,
Oba
Part Number: REF6025 Other Parts Discussed in Thread: ADS1259 Hi,
I apologize that this topic is not related with the REF6025 directly.
Please move to proper forum if this forum is inappropriate.
I watched the delta sigma-voltage reference training video…
Hi Prajwal Bhuse,
Here are the answers to your questions:
Prajwal Bhuse said: what if i give 2.5v directly to ADS1256 as reference ?
Yes this makes sense because 2.5V is the nominal voltage reference required by the ADC and specified in the datasheet
…
Part Number: REF6025 Other Parts Discussed in Thread: REF5020
Dear Sir, please answer
I asked a question about REF6025 in Jun 2017. Please see my circuit in attach.
I need to adjust frequency of generator - 16,384,000 Hz. I need to vary voltage in the…
Part Number: REF35 Other Parts Discussed in Thread: ADS127L21 , REF54 , REF4132 , , REF70 , REF6025 , REF2025 It is unclear to me if I need a reference buffer on the output of my voltage reference before it connects to my ADC. How do I know when I may need…
Hi Theo,
Yes, using a separate LDO for IOVDD will likely be a lower noise solution verses sharing IOVDD and AVDD.
Also, if you want a lower noise reference that can support the highest data rates, the REF6025 will be a better choice. The REF3425 should…
Part Number: REF6025 Dear Sir, please, answer
I'd like to use REF6025 for voltage control of Voltage Control Oscillator JT53LV (16 MHz) . Oscillator has control input for feed 1.5 V+/- 1V voltage. I want to adjust this voltage with a potentiometer…
