Part Number: REG710-33 Other Parts Discussed in Thread: REG710-3 I designed my circuit with REG710-3.3V (Fxied output voltage) model.
[Issue statement]
Output voltage is 1.69V when EN pin is pulled low.
** Note: When my mcu give HIGH on EN pin…
Part Number: REG710-33 Other Parts Discussed in Thread: TLV767 Hi,
Please allow to ask about line regulation about REG710-33. It will be helpful if you have similar device that have line regulation curve in datasheet.
Best regards,
Satoshi
Part Number: TPS60240 Other Parts Discussed in Thread: REG710-33 , Dear forum,
I wanted to ask if it is safe to operate two TPS60240 devices in parallel similar to the application shown for the REG710-33 in the datasheet (reg710-33.pdf) on page 15?…
The TPS60400 is a voltage inverter, and will not help you get a boosted voltage. To boost from 2.5 V to 3.3 V, use something like the REG710-33. For 5 V, use something like the TPS60140.
What is the voltage at the LDO's input? Would it be possible to…
Hi Jared,
it would be great to get more details of the power requirements. (Vin, Vout, Load...)
For 5Vout the TPS60150 could replace the MCP part.
For 3.3Vout the REG710-33 is an option but the maximum output current is 60mA.
Looking forward…
Hi Mike,
It's not clear what debugging has been done since your initial post?
Also, it usually doesn't work to breadboard (I'm referring to the breadboards we used in college where everything was through-hole) switching power supplies, such as the…
Hi,
I've attached the 2013 User's Guide for power products. Starting on page 53 you will find a selection of PWM controllers. many of these teh frequency can be varied according to external criteria.
As an example if you use a UC3842 it is a simple…
Gary,
Most any of our power controllers with dual output capability will provide the control. See attached document starting at page 50 with the dual output controllers on page 53 and 54 and choose what features you want.
Regards,
John
Hello,
The UCC3806 is a dual output controller though it can be used in a flyback where only one of the outputs are used to drive the switch it might be better to choose a single output controller. Look at page 46 of the attached under General Purpose…
