Part Number: REG71050 Hi Team,
We are currently using the RT9361AGE, and the EN pin has a dimming function.
Does the REG71050 also have a dimming function similar to this, allowing adjustment of LED brightness?
Thanks
Part Number: REG71050 Other Parts Discussed in Thread: TPS60150 , Hi TI Team, I am looking to boost a 3V3 rail to 5V in order to power a load of max 30mA. The PCB will be fitted into an enclosure with temperature sensor.
I would like to ask which solution…
Part Number: REG71050 Other Parts Discussed in Thread: TPS61299 , TPS63900 , LM2775 , TPS60150 , TPS60151 Dear Ladies and Gentlemen,
I'm experiencing the problem, that the output voltage is higher than specified:
It measures 5.41V @ 80 uA load …
Part Number: REG71050 Other Parts Discussed in Thread: REG710-5 , REG710-3 , TPS61299 Hello,
I'd like to use the REG71050 for boosting an input that ranges between 1.8 V and 3 V. The dataheet table for input operating voltages, table 7.3, indicates…
Part Number: REG71050 Hi Folks,
What should the REG71050DRV's thermal pad be electrically connected to on the PCB? I would presume GND, but need confirmation as it's not indicated in the datasheet.
Thanks!
Part Number: REG71050 We have a customer inquiring about the enable pins timing and any limitations for REG71050DDCT,here are the inquiry from the customer in verbatim:
I want to use REG71050DDCT to drive a 5V buzzer with 5V and ~30ma.I was thinking…
Part Number: REG71050 Dear Sir or Madam,
I would like to use the REG71050 to supply an LED matrix in a battery powered application. The measured repeating current peaks exceed the 60mA given in your data sheet. Could you please check the attached waveform…
Part Number: REG71050 Hi, Could you tell me about REG71050 out put current spec. Please check the attached waveform. REG71050.pdf 1.The inrush current is 200 mA. Is this all right? 2.The RMS output current is 66.3 mA. Is this all right? The recommended…
Part Number: REG71050 we're planning to use the REG71050DDCT in a product that must operate in the presence of explosive gases and so be intrinsically safe to the ATEX ia IIC T4 standard. Don't worry, it's up to us to make the IC safe and we'll take full…
Part Number: REG71050 What circuit potential should the exposed thermal pad be connected to? I can't see any mention of that on the data sheet. I have connected to the ground plane on my schematic but I don't want to get the prototype boards made if that…
