Hi, I would recommend you use our range estimator tool, which allows you to calculate range depending on multiple settings, including the amount of walls and the material they are made of. This way, you can optimize your antenna and TX power choices.…
If you look at https://www.ti.com/tool/RF-RANGE-ESTIMATOR, the calculation include what margin TI uses. The margin is an installation margin mainly since you could have negative interference some places etc. You should also look at the noise level where…
Hi,
Just a balun by itself might not be sufficient to suppress the harmonics. You may need extra filtering after the balun.
I don't think CCS supports 8051 compiler. We typically use IAR Embedded Workbench.
Please see this app note: https://www…
Other Parts Discussed in Thread: SIMPLICITI , CC2500 , TEST2 Hi ,
I am using two RF CC2500 device which communicate to each other using SimpliciTI protocol (Peer to Peer).
The range which i get is 3 m, which is very less.
below is the register setting…
Hi,
Please look at the CC1312R7 for only sub-1 GHz or CC1352P7 for both sub-1 GHz and 2.4 GHz.
For the released and supported PHYs, please download SmartRF studio.
For a range estimation, please use https://www.ti.com/tool/RF-RANGE-ESTIMATOR
Regards…
Hi Derek,
I would recommend to look at our RF-RANGE-ESTIMATOR tool: https://www.ti.com/tool/RF-RANGE-ESTIMATOR
This should provide you the most accurate results.
Best regards,
Zhang,
It is not entirely clear what you mean by your question. If I am understanding correctly, you can use two different chirps in a single frame that both span the same VCO. In this case, it is VCO1 that covers 76 - 77 GHz.
But as I stated in…
Part Number: CC2640R2F Other Parts Discussed in Thread: RF-RANGE-ESTIMATOR Hi,
I had a hardware with CC2640r2f as a Network Processor and Sable xr2f as a BLE module.
I'm using the SDK version "simplelink_cc2640r2_sdk_2_40_00_32".
with the current…
Hi Yingtao, The RF range is highly dependent on the environment and also very sensitive to the Transmitter and Receiver height from the ground. There is a range estimator tool that you can use, where you add the different materials that are in the path…