Hi Tim, Yes, sub1GHz will typically give you a much better range. The range is dependent on a lot of factors, I would suggest you to use our range estimator tool and include factors for your specific use-case to get an estimation of range.
https://www…
Part Number: LP-CC1352P7 Dear TI Engineers,
Finally, I have completed my test Wi-SUN Network on a Raspberry Pi 4. I can also run the built-in Wi-SUN monitor web portal.
I still have some questions about this technology:
From within a Linux host…
Hi Puyash,
1) You can refer to the TI 15.4-Stack or Z-Stack Battery Life Calculator as all protocols mentioned are based on the IEEE 802.15.4 MAC/PHY.
2) Range depends on frequency band, throughput, and output power (max 5 dB for the CC2652R7),and…
Hi all
I'd like to use more than one EZ-430 433 MHz inside the same building. They will be placed in different rooms but not very distant from each other.
Right know i see many interferences between watches: how could I reduce RF range to avoid…
Hi,
The calculation of range is highly dependent on the additional environmental factors that comprise the wireless link between the two nodes - things such as obstacles, orientation of the launchpads, type of antenna, other sources of EM interference…
1. It’s more related to TX power you use.
2 Yes, it can use bootloader to do OTA.
3. According to my experience, it should less than 100ms when Zigbee device is in radio coverage.
4. About 80 bytes if you follow ZCL payload without using Zigbee…
Hi Davis,
CC8520 + CC2590 should result in about 13 dBm output power maximum though the application note doesn't specify what power they measured. This is based on the data from the CC8520 datasheet and the CC2590 datasheet. For example the maximum…