For range estimation, look into https://www.ti.com/tool/RF-RANGE-ESTIMATOR . Playing with this will give a better understanding of how the different parameters impact range.
For long range you typically need low data rate to get a narrowband system…
Increased the output power with 6 dB to compensate the LB for a LNA on the receiver side; this is roughly 10m distance. Without the LNA, then a rough estimation would be around 5m.
The accuracy of the range distance is very rough so you should measure…
Hi,
1) Before BLE 4.1, only one connection is allowed. Using BLE 4.1 or latter, the number of simultaneous connections is limited by the device's memory (RAM). For CC2640R2, the limit is 3 simultaneous connections. For CC2642R, the limit is 8 simultaneous…
For dimensions you can open the gerber files in a gerber viewer and find the measurements there.
The PCB antenna is sufficient for basic testing. You can use www.ti.com/.../RF-RANGE-ESTIMATOR to estimate range.
Hi,
As per ETSI Standard ( EN 300 220-2 V3.2.1) , the Maximum ERP ( Effective Radiated Power) is 10mW with <10% Duty Cycle in 433MHz band ( Band H).
Whereas in 868MHz band (Band L) , the Maximum ERP is 25mW with less than <1% Duty Cycle.
Yes, more…
Hi Elango,
If you make a proprietary solution and use a reasonably fast data rate (e.g. 200 kbps) you may be able to get below 1 ms.
If you want to use a standardized network like TI 15.4-Stack or you want use a slower datarate to achieve longer range…