TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel


Search tips
Showing 12,573 results View by: Thread Post Sort by
  • RE: BOOSTXL-AOA: Connection loss when wall is between devices

    Mustafa Homsi
    Mustafa Homsi
    According to TI RF Range Estimator document listed on the LAUNCHXL-CC26X2R1 website, we still should get a reasonable range even through walls (attached the calculator for reference). I agree that walls are going to degrade the signal strength but the…
    • over 7 years ago
    • Bluetooth®︎
    • Bluetooth forum
  • Answered
  • RE: CC1310: Easylink: Optimize transmission settings

    Siri
    Siri
    Resolved
    It is not clear to me what you are struggling with? Is it to get high enough throughput, or is it the packet loss? I would strongly start by verifying that you are getting the performance you should expect, before working on the throughput. Using…
    • over 7 years ago
    • Sub-1 GHz
    • Sub-1 GHz forum
  • CC1352P: Questions on performance of CC1352P (continuation from internal thread)

    Lauren Mayfield
    Lauren Mayfield
    TI Thinks Resolved
    Part Number: CC1352P Hi, I'm posting this question on behalf of my customer. Please see e-mail thread for context. I'm following up on the questions the customer would like to close. 1. We would like to evaluate the CSMA/CA slotted capability. We…
    • over 7 years ago
    • Bluetooth®︎
    • Bluetooth forum
  • AWR2243: AWR2243: Support for CW or stepped-frequency CW operation and raw ADC capture

    zhang xiaozhong
    zhang xiaozhong
    TI Thinks Resolved
    Part Number: AWR2243 Hello, We would like to evaluate whether the AWR2243 can be used for stepped-frequency continuous-wave (SFCW) ranging. In our intended method, each transmitted signal is a flat, constant-frequency CW tone with no frequency slope…
    • 2 months ago
    • Sensors
    • Sensors forum
  • RE: AWR2243-2X-CAS-EVM: MMWCAS-RF-EVM

    Samhitha Bobba
    Samhitha Bobba
    Hi Javier, There might be some range bias which can be caused due to various factors. Because of imperfections in antenna layouts on the board, RF delays in SOC, etc, there is need to calibrate the sensor to compensate for bias in the range estimation…
    • 9 months ago
    • Sensors
    • Sensors forum
  • AFE8192: Minimum Input Frequency and Power Consumption calculation

    Marinus Aigner
    Marinus Aigner
    Part Number: AFE8192 Hello, According to your website, the minimum receiver frequency is 400 MHz; however, the detailed data sheet—in Table 5.6, "Electrical Characteristics"—lists an RF input frequency range with a minimum of 600 MHz. Could you tell me…
    • 16 days ago
    • RF & microwave
    • RF & microwave forum
  • IWR6843AOPEVM: Spectrum Data

    Zai Mei Chen
    Zai Mei Chen
    TI Thinks Resolved
    Part Number: IWR6843AOPEVM Please assist with following spectrum data. TX Parameters needed (DD1494 Transmitter page block listed) RF curves (-3, -20, -40, -60dB curves). We need at least 55dB of dynamic range, preferably 70dB (block 12a-d) …
    • 8 months ago
    • Sensors
    • Sensors forum
  • RE: AWR1843AOPEVM: Range FFT accuracy

    zigang Yang
    zigang Yang
    Hi, there: The range resolution is related to the RF bandwidth. In order to reduce your range resolution from 72cm to 10cm. You can change your RF slope from 10MHz/us to 72MHz/us. channelCfg 15 7 0 adcCfg 2 1 adcbufCfg -1 0 1 1 1 profileCfg 0 77 7…
    • 10 months ago
    • Sensors
    • Sensors forum
  • Answered
  • IWRL6432: Request for Technical Comparison Material: TI 60-GHz mmWave Radar vs. Third-Party 24-GHz 1T1R Radar

    Jack
    Jack
    Resolved
    Part Number: IWRL6432 Other Parts Discussed in Thread: IWR6843 , Hello TI E2E Team, We are currently comparing TI’s 60-GHz mmWave radar solutions with a third-party 24-GHz 1TX/1RX radar product for customer applications such as indoor presence detection…
    • Resolved
    • 3 months ago
    • Sensors
    • Sensors forum
  • RE: CC2530:Prośba o pomoc w wyborze układu

    Ryan Brown1
    Ryan Brown1
    Hello Piotr, Here is an article I found from Digi to help explain compatiblity: https://www.digi.com/support/knowledge-base/compatible-digi-xbee-products And a relevant E2E thread, although I'm sure you would be able to find more: https://e2e.ti.com…
    • over 1 year ago
    • Zigbee & Thread
    • Zigbee & Thread forum
<>

Didn't find what you are looking for? Post a new question.

  • Ask a new question