Part Number: TPS6594EVM Hi,
I was wondering if I could be provided with an NVM config file to apply to my PMIC TPS65941212EVM. I want the same configuration as the TPS65941319Q IC. Thanks
Part Number: MSP432E401Y
Hi, Ti engineers! Thank you very much for your help. I asked similar questions on the forum a few days ago. You helped me solve some problems, but I didn't get any reply when I asked later, so I asked again.
When I use msp…
Part Number: LP876242-Q1 Other Parts Discussed in Thread: LP876242Q1EVM Tool/software: Hi,
We are using LP876242B0RQKRQ1 in our design. It is connected with FT4232H which is connected to the PC.
Can you please answer the following queries?
1. Through…
Part Number: TPS6522005-EP Tool/software: Dear Team,
For the above mentioned PMIC I have some queries, Please check on this and address a solution and clarification as soon as possible. 1. How the BUCKs and LDOs are configured. Which tool to be used…
Part Number: TPS6593-Q1 Hello,
I am currently programming a TPS6593-Q1 PMIC using a Scanflex 2 Cube Boundary Scan Controller via the MPP channels. Communication is done over I²C using the default PMIC address 0x28, and CRC is disabled.
We have observed…
Hi Seungwoo,
GPIO10 is needed to be pulled down, otherwise for blank 0400 device it will default to SPI and not I2C.
GPIO4 is only if you want to turn off CRC. If using the Scalable PMIC GUI it should be no problem for the GUI to handle CRC. Otherwise…
Hi Luke,
Please refer to the TPS6594-Q1 datasheet for details about device configuration options and register map: https://www.ti.com/lit/gpn/tps6594-q1
And the Scalable PMIC GUI can be used to configure the device: https://www.ti.com/tool/SCALABLE…
Hello Tino,
Tino Huuskonen said: Yes, you would need to configure the NVM in Scalable PMIC GUI. See "Scalable PMIC NVM Update Guide" in the product folder: LP8764-Q1 data sheet, product information and support | TI.com
I have gone through the Scalable…
Part Number: TPS6594EVM Hi there,
I have TPS65941111EVM/BMC047A and cannot connect to it in Scalable PMICs GUI v5.1.0). Clearly in device manager, ACCtrl COM27 is availabe but GUI cannot find it as highlighted below.
Regards,
Charles
