Part Number: CC1110-CC1111 Other Parts Discussed in Thread: SIMPLICITI Hi team,
Here's the request from the customer:
The source program used is simple_Peer_to_Peer of simpliciTI-IAR-1.2.0.
Customer used TI's example simple_Peer_to_Peer to do a peer…
Chip select is optional but highly recommended. The SPI slave can still process communication using other parameters but the configuration is made more difficult.
Regards, Ryan
Hi Meng,
Those dots are defective pixels. You can use the Defect Pixel Correction (DPC) plugin to remove the defective pixels.
Please try the following after starting the DPC plugin:
1. choose Legacy Mode for simplicity
2. start with large thresholds…
Part Number: CC430F5137 Other Parts Discussed in Thread: SIMPLICITI Hi everyone,
I've built up my app on top of the AP HUB example app and the issue with it is that sometimes, after a software reset, AP's RF functionality gets jammed. It stops receiving…
Hi Mark,
I merged the two threads for simplicity.
1. Resistors are not required, VOCM is required.
2. Increasing the VSOP to be 5V will increase the output range of the PGA281 and will in turn increase the usable range of the ADC. If you would like I can…
Hi Jiang,
Thank you for your feedback. I have added a 200uA Iain current source. You can also add one externally to the previous model.
The datasheet gives a 2.5 Ohm Routh value: I have found that this seems to be a more accurate representation of the…
Hi Eve,
TPS66020 is more towards PD controller type part with integrated FETs for dedicated SRC and SNK paths. TPS25947 is a simple back-to-back FET device with primary focus on protections. TPS25947 do not allow reverse current.
I am not aware of Intek…
Part Number: TMS320F2800135 Tool/software: The field-weakening PI controller appears to always saturate its output (-45 degrees in this case) once Vs_V (commanded Vs) exceeds VsRef_V (max voltage output).
Is this done by design for simplicity?
Ideally…
For simplicity, I would recommend enabling EE even if you don't need it. The EE parameters can be programed such that EE has no real effects. Keeping EE off has additional H/W constraints.
I believe by SDK 11.0, the following combinations would be supported…
Part Number: UCC5304
Tool/software:
Dear Experts, I would like to use UCC5304 to drive an SiC MOSFET. I wonder if we can use this IC for +15/-4V switching requirement. I don't see COM pin on this IC and VSS is connected to the GND in. For example,…
