Part Number: MMWCAS-RF-EVM Other Parts Discussed in Thread: MMWCAS-DSP-EVM , , AWR1243 The used evaluation board: MMWCAS-RF-EVM, MMWCAS-DSP-EVM
The used sortware: mmWave_Studio (latest version)
Radar operating mode: MIMO
We are very pleased to see that…
Hey A.,
I must commend you on the great problem solving skills in this supply constraint environment!
The PCB footprints for SOT-23|8 (DCN) and SOT-23-Thin|8 (DDF) package are very similar and may populate on to the same PCB footprint. We do this on our…
Part Number: TLV9061 I'm looking for a tiny FET op-amp for a photodiode preamplifier application.
1. Single Supply - 3 volts typical.
2. Low input current comensurate with JFET input op-amp, 10 pA typical.
3. At lease 4 MHz Gain Bandwidth Product…
Part Number: BOOSTXL-AOA HI guys,
My customer has been waiting on the smaller version of the angle of arrival BLE board, since we heard it was in development. Whats the status of that?
Thanks,
Brian
Hi Albert,
LS FET has small RDS(on), even turn-on at minimum time may cause the output voltage dip, on other side, the LS can't sink current if the IC can't works at Force PWM mode.
B R
Andy
Part Number: TPS65130 We are trying to use the TPS65130 to provide +/- supply to two Op-Amps which are being used to drive two transducers which operate at 2MHz. Our current issue is that when running these amplifiers with a bench top DC supply we operate…
Hello TJ,
There are not any specific boards for these devices, they are pretty generic and simple and easy to prototype.
We do have SMT to DIP adapter boards:
DIP adapter evaluation module
SMALL-AMP-DIP-EVM
There are also similar, lower cost SMT to DIP…
Part Number: MSP430F6736A Sir, we are working as E-meter project. MSP430F6736A, this TI ic is suited for my application.
your datasheet is mentioned, When CT or shunts are used, make sure the voltages across CUR2+ and CUR2- does not exceed 920 mV
my doubt…
Hello Kazuya,
Kazuya Nakai59 said: Q1. Can VSSOP8pin package be assembled to the EVM?
No, the DUAL-DIYAMP-EVM is only compatible with SOIC-8 package amplifiers. I recommend the customer sample TLV9052 in SOIC-8 package for the EVM, and design with VSSOP…
Part Number: LT1014-MIL Hello
I have several questions for device
When the upper OP-AMP is a normal Vcc input and the lower OP-Amp is an abonormal Vcc input, the voltages at points 1 and 2 are not equal. Can leakage occur at the input of OP-AMP when the…