Part Number: MSP430F6736A Sir, we are working as E-meter project. MSP430F6736A, this TI ic is suited for my application.
your datasheet is mentioned, When CT or shunts are used, make sure the voltages across CUR2+ and CUR2- does not exceed 920 mV
my doubt…
Hello TJ,
There are not any specific boards for these devices, they are pretty generic and simple and easy to prototype.
We do have SMT to DIP adapter boards:
DIP adapter evaluation module
SMALL-AMP-DIP-EVM
There are also similar, lower cost SMT to DIP…
Part Number: TPS2121 We are using the TPS2121 as given below in our project for switching between +12V_SPA0 and +12V_STBY and we did some measurements that does not meet design requirements as the output voltage DIP is seen when there is any switching…
Hi Albert,
LS FET has small RDS(on), even turn-on at minimum time may cause the output voltage dip, on other side, the LS can't sink current if the IC can't works at Force PWM mode.
B R
Andy
I wasn't sure so I reflashed the EVM with the OOB binary and tested once again with CLI, but I am not receiving any data, however mmWaveStudio is still working fine.
The DIP switches on the EVM are set to MMWAVEICBOOST mode (first 4 are off, while…
Hi
Do you have the mother board which can connect with EVM board.
if you don't have the MB, you can connect like below:
After connecting like below, you need PPC3 to generate the initial code, and use i2c flash the initial code to Amp.
Amp will work…
Part Number: ADS4242 The datasheet says the ADC can handle a 2 Vpp signal, but in practice the ADC clips and can only handle a 1 Vpp signal. I'm using the ADS4242 EVM board with a signal generator for the input. The input signal is run through an op amp…
Mukuno-san,
Yes, PSRR.
Precision Amplifiers uses a large supply voltage change when production testing our op amp PSRR. Using a large voltage change is a more rigorous test than when a small voltage change is used. It is essentially a DC test and that…
Part Number: TLV752-EVM Other Parts Discussed in Thread: TLV752 , Is there any small card (a small daughter board) for TLV752? Much smaller than TLV752-EVM? Even without jumpers for select options. What is the PCB size of TLV752-EVM (Its look very large…
Part Number: LT1014-MIL Hello
I have several questions for device
When the upper OP-AMP is a normal Vcc input and the lower OP-Amp is an abonormal Vcc input, the voltages at points 1 and 2 are not equal. Can leakage occur at the input of OP-AMP when the…
