Part Number: SN65HVS882 Hi all,
Can the thermal pad on the SN65HVS882 be connected to ground?
The PowerPAD drawing says to connect to the appropriate copper plane shown in the electrical schematic for the device. However, the thermal pad isn't mentioned…
Part Number: SN65HVS882 Other Parts Discussed in Thread: ISO1212 , ISO1211 , I'm trying to integrate the part in my Digital Input module but our digital input fields values are within range of 36-72V, nominal is 60V fo 'ON' value.
what is the…
Part Number: SN65HVS882 Hi Sirs,
Sorry to bother you.
As title,
1. Do we have Digital Output solution can correspond 882?
2. Does 882 need any FW or driver to control?
Thanks!!
Part Number: SN65HVS882 I am trying to support an old design that uses the chip. The RE outputs are left open. Is this OK? I notice in the datasheets that these are tied to an LED to ground.
Part Number: SN65HVS882 In Figure 21 of the datasheet, an application circuit demonstrating the system protection for the SN65HVS882 device is shown. for the input terminals, it depends barely on the 1.2kW resistor.
My question is:
- what is the maximum…
Other Parts Discussed in Thread: SN65HVS882 Hello guys,
One of our customers is looking for a device which is like SN65HVS882 without the serdes portion.
Do you have such device?
Your reply would be appreciated.
Best regards,
Kazuya Nakai.
Part Number: TMDSICE3359 Other Parts Discussed in Thread: SYSCONFIG , SN65HVS882 Hello,
I am new to embedded Linux. I want to start with TI sitara.
I have TMDSICE3359 eval board.
Please provide me some source from where I can begin.
Regards,
Imran
Is there a standard way to force logic /logic 0 to the above mentioned product line to ensure correct operation in high rel system. Or is there any alternative way to ensure the above product line is not suffering from stuck at failures?
Other Parts Discussed in Thread: SN65HVS882 Folks,
I have an AM335X_BOARD_TYPE_ICE, and I am trying to read the digital pins from the SN65HVS882 (8 digital input serializer). I can read bits 0, 1, and 3 successfully, but when I try to ready the rest of the…