Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: SN65LVDS33-EP Hello,
For the SN65LVDS33MDREP, the only “operating factor” of 7.6mW/C is given (which I in turn calculate 131.6C/W for theta-JA). Do you have unpublished theta-JC and theta-JB?
Thanks,
Adam
Part Number: SN65LVDS31-EP Hi Support,
The data sheet did not include HBM/CDM.
Please tell me the test results of ESD.
-Part#:
SN65LVDS31MDREP
SN65LVDS33MDREP
-HBM: ? V
-CDM: ? V
Best Regards;
Hideyuki
Part Number: SN65LVDS33-EP Hi team,
My customer is looking for 6bit LVDS receiver which supports ~105degC. They can accept 4bit+2bit or 8bit devices as well.
Their requirement is 60MHz and Vcc=3.3V. I believe that SN65LVDS33-EP x2pcs would meet their…
Part Number: SN65LVDS33-EP Original details: 2 questions on the SN65LVDS33-EP (i.e. SN65LVDS33MDREP), Quad LVDS Diff Line Rx 1. I am using this part to convert a differential LVDS 100 MHz clock to TTL for a frequency measurement on a scope. Can you tell…
Part Number: SN65LVDS33-EP Hi Team,
My Customer is asking for the junction to board and junction to case thermal resistances of our SN65LVDS33MDREP device. Can you share with me this data?
Thanks in advance.
Regards, -Renan
Part Number: SN65LVDS33-EP Hello
I assume that specifications in the VID for SN65LVDS33-EP are valid over lifetime of the device? Am I correct?
I'm specifically concerned about the Part-to-Part skew (1.2ns max). Part-to-Part skew as I understand refers…
Part Number: SN65LVDS33-EP I just wanted to confirm that the only way to guarantee a high impedance state at the output is to power the device and disable the output.
Is it required to drive both of the enables to put the device in High Impedance at…
Part Number: SN65LVDS33-EP Hi E2E,
Good day!
I just wanted to confirm that the only way to guarantee a high impedance state at the output is to power the device and disable the output. what does the output do when the device isn't powered, is it possible…
A device named "SN65LVDT33-EP" does not exist. There is only the SN65LVDS33-EP without integrated termination resistors.
Unused inputs must not float. For the SN65LVDS33-EP, the unused A/B inputs should be shorted (directly or with a termination…
