Part Number: SN74AUP1T34 Tool/software: I have precise clock source 25MHZ with 3.3V amplitude.
I have FPGA design where this clock shall be entered to bank 1.35V.
Clock is entered to PLL inside FPGA, and used for DDR3 IP design.
I was looking for…
Part Number: SN74AUP1T34 Tool/software: I have consulted the datasheet of the product,
but I cannot find any information on the internal pull-up resistor values connected to the input and output.
Can you tell me the internal pull-up resistor values…
Part Number: SN74AUP1T34 HI,
I'm using SN74AUP1T34DCK as unidirectional level translator for the RESET signal which is shown in below schematic screenshot.
I would like to just confirm that here I have given 3.3V to VCCA and 1.8V to VCCB, is that…
Part Number: SN74AUP1T34
Hi,
I was thinking of using this IC as a discrete buffer for two synchronous clocks. The issue I'm running into is finding information on the minimum propagation delay for operating VCCA & VCCB at 3.3V. Is this specification…
Part Number: SN74AUP1T34 Other Parts Discussed in Thread: SN74LVC1G17 , SN74AUC1G17 , SN74AUP1G17 , SN74AUP1G34 , SN74LV1T34 , SN74LVC1G34 , Hi,
The related thread stated:
"For down-converting, you can use the SN74LV1T34, or any buffer with an overvoltage…
Part Number: SN74AUP1T34 Hi team,
Can NC pin of SN74AUP1G34DPWR be connected to signal? We are considering using it to replace SN74AUP1G08DPWR, but one input pin will become NC, please teach us if this will be no problem.
Best, Zeming
Part Number: SN74AUP1T34SN74AUP1T34 specifies input transition rise or fall rate as VCCA=3.0V to 3.6V, VCCB=0.9V to 3.6V, but what is specified when VCCA is less than 3.0V?
We are considering using VCCA=1V and VCCB=3.3V, and would like to know the…
Part Number: SN74AUP1T34-Q1 Hello Team,
I had a datasheet question pop up. We are using the SN74AUP1T34-Q1 voltage level translator, and I’m trying to understand the VOH and VOL levels from section 6.3. Specifically where there might be concern is the…
