Answered

• SN74LVC2G34: Short Circuit Current

  

  Mark Ackerson

  Resolved

  Part Number: SN74LVC2G34 Customer is using SN74LVC2G34DBVR to drive an external LED via via 49.9ohm resistor (sourcing current). The customer is concerned with short circuit on the external LED wiring damaging the SN74LVC2G34DBVR due to current above the…

  • Resolved

  • over 3 years ago
  • Logic
  • Logic forum

• SN74AHC126: UART Buffer 115200 baud

  

  Louis Thuilliez

  TI Thinks Resolved

  Part Number: SN74AHC126 Other Parts Discussed in Thread: SN74LVC2G34 Hi, Does the SN74AHC126 can buffer a UART communication at 115200 baud in RX and TX ? Thanks for your help, Louis

  • 18 days ago
  • Logic
  • Logic forum
Answered

• SN74LVC2G34: Device Geometry

  

  Lee Merrett

  Resolved

  Part Number: SN74LVC2G34 I have been asked to find the device geometry for the above device and generally the SN74 series of logic? Where can i find this type of data online?

  • Resolved

  • over 3 years ago
  • Logic
  • Logic forum
Answered

• RE: SN74LVC2G07: clock buffer

  

  Clemens Ladisch

  Resolved

  Open-drain outputs have slow rising edges, depending on the value of the pull-up resistors. Use an actual level shifter like the TXU0102, or a buffer with overvoltage-tolerant inputs like the SN74LVC2G34. The typical skew is less than 1 ns. There is no…

  • 1 month ago
  • Logic
  • Logic forum

• SN74LVC1G34: SN74LVC1G34 vs SN74LVC2G34 (Input transition rise or fall rate)

  

  Oliver Schmutz1

  TI Thinks Resolved

  Part Number: SN74LVC1G34 Other Parts Discussed in Thread: SN74LVC2G34 , Hi Community I used until now a dual Buffer gate SN74LVC2G34. But now I just need only one buffer (PCB size is also a problem). But with same or better speed performance than the…

  • over 3 years ago
  • Logic
  • Logic forum
Answered

• SN74LVC2G34: What will SN74LVC2G34 output if GND floating

  

  Mingmo Zhu

  Resolved

  Part Number: SN74LVC2G34 Hello there, We have a circuit need a buffer to drive a MOS Q1 to disconnect GND1 and GND2, as below. My concern is what will SN74LVC2G34 output if it's GND is floating after Q1 is turned off? Will it damage SN74LVC2G34? or the…

  • Resolved

  • over 4 years ago
  • Logic
  • Logic forum
Answered

• SN74LVC2G34: Use on PWM

  

  Shu-Cheng LIN

  Resolved

  Part Number: SN74LVC2G34 Hi Sirs, Sorry to bother you. We would like to know does SN74LVC2G34DCKR buffer could be used on the PWM signal? We Want to extra PWM driver ability

  • Resolved

  • over 4 years ago
  • Logic
  • Logic forum

• RE: TXB0106: Device malfunction, maybe related to OE pin

  

  Clemens Ladisch

  If the TXU's input leakage (up to 2 µA) is too high for your application, use translators like the SN74AXC4T245. For translating to a lower voltage, you can also use any buffer with overvoltage-tolerant inputs, such as the SN74LVC2G34 or SN74LVC125A.…

  • 2 months ago
  • Logic
  • Logic forum
Answered

• SN74LVC2G34: maximum speed could support

  

  Polly Chung1

  Resolved

  Part Number: SN74LVC2G34 Dear Team, May I know what is the maximum speed of SN74LVC2G34? Can it support up to 102MHz for QSPI clock? Thank you. Regards, Polly Chung

  • Resolved

  • over 4 years ago
  • Logic
  • Logic forum

• TXS0102: Schematics Review

  

  Desireddy Teja Reddy

  TI Thinks Resolved

  Part Number: TXS0102 Other Parts Discussed in Thread: SN74LVC2G34 Hi Team, We are using the TXS0102DCURG4 Level translator part in our schematics. I had attached the schematic Images below, Kindly review the schematics and share your valuable feedback with…

  • 5 months ago
  • Logic
  • Logic forum

Didn't find what you are looking for? Post a new question.