Part Number: TAC5111
Hi,
I designed a PCB using the TAC5111.
In my system, an MCU sends audio data to the TAC5111 via an I2S interface, and the TAC5111 outputs the audio signal.
I am observing approximately 90 ms of delay from the time the I2S…
Part Number: TAC5111 Hello, my team is developing a test board using a TAC5111 codec as the audio interface with ADC and DAC functionality. It is communicating with our DSP processor over an I2S link and we have tested in both DSP master and codec master…
Part Number: TAC5111
We are observing the following error bits and would like to understand the possible causes for these:
Bit 6 in INT_LIVE0 – Indicates interrupt due to PLL lock.
We have referred to Section 4, “Determination of Incoming Timing…
Part Number: TAC5111 I've got two similar input configurations (Single Ended AC coupled) used on IN1PN and IN2PN... my IN1 is working properly. But as soon as I use ADC_Ch_SWAP (0x77 bit 1) to swap inputs to the unique ADC, I've got nothing.. I switch…
Part Number: TAC5111 Other Parts Discussed in Thread: TAS2563 , TAC5112EVM-K , TAC5112 Hello,
we are developing a device that should support AEC (acoustic echo cancellation). The TAC5111 chip may be suitable for this purpose, as according to the data…
Part Number: TAC5111 Tool/software: hi
from tac5111 datasheet, I see the register 0x22 can set echo reference for channel 1. is it for echo cancellation.
if yes, how to use it ? please help provide detail usage . thanks very much
Part Number: TAC5111 Tool/software: hi
when use the register 0x37 to configure tac5111 as I2S controller, how to provide the input CCLK clock to tac5111 ?
best regards
Part Number: TAC5111 Other Parts Discussed in Thread: TAC5112 I need a I2S synchronous sample rate converter.
Convert a 16KHz I2S input to a 48KHz I2S output.
From the TAC5111 datasheet and the TI "TAX5X1X Synchronous Sample Rate Conversion" App Note…
Part Number: TAC5111 Tool/software: hi
from tac5111 datasheet chapter 7.3.9.1.9 , user can download the document "Using the Automatic Gain Controller (AGC) in TAx5x1x Family application report", but actually it is not for TAx5x1x, please help provide…
Part Number: TAC5111 Hi, We are using TAC5111 in a new design with i.MX8M Plus. For playback we have 1x analog speaker with amplifier connected to OUT1P/OUT1M.
For recording we have 2x PDM microphones on pins GPIO2 (Clock) and GPIO1 (Data). The microphones…
