Part Number: TAS2505-Q1 Other Parts Discussed in Thread: TAS2505 Tool/software: Hi Team,
We would like to use TAS2505-Q1 as our audio amplifier and below is our requirements.
I want to check if TAS2505 can achieve 32step volume control? We used VI(AUX…
Part Number: TAS2505 Tool/software: Hello, We are facing an issue with the design of TAS2505 (Literature Number: SLAU472C) that requires a complete shut down to the sound in case overcurrent was detected by the chip to prevent over heating through register…
Part Number: TAS2505-Q1 Tool/software: Hi team,
I accidentally damaged the TAS2505-Q1 on my board, so I would like to double check the
over current behavior.
Q1. How long does it take to detecting over current to shutdown the output?
Q2. How much is…
Hi Arthur,
Great news, in the end this was down to the TDM data not being correct.
We were using the second TDM line (Teensy supports 2) and only checked the data was correct on the first one. There is a bug with TDM2 which meant that some random data…
Part Number: TAS2505 Other Parts Discussed in Thread: PCM3168 Tool/software: Hello,
Could you please confirm that TAS2505 can decode a TDM signal with only BCLK, FSYNC (WCLK) and DIN?
There is no need to feed in the MCLK as well, does it?
Thank you
Part Number: TAS2505-Q1 Tool/software: HI!
I'd like to use pull-up resistor of TAS2505-Q1 SDA and SCL with 1.5 kΩ.
I could not find output low level current (IOL) of SDA and SCL in the data sheet. Is it possible to set 1.5 kΩ?
Please…
Part Number: TAS2505 Tool/software: Hello,
I would like to test if there's any sound clipping from TAS2505's DAC, and after studying the reference guide, I noticed there's a clipping flag bit on P0 R39. However, what I don't quite understand is exactly…
Part Number: TAS2505-Q1 Hi Ivan,
Our customer has some confusion about the datasheet.
The DVDD supply recommended value is 1.65~1.95v.
But on the power supply recommendations; digital core power range from 1.26v to 1.95V
My customer have some confusion…
Part Number: TAS2505 if The reset pin held to high state by pulling it to I/O , and left open without any master control will it cause any issues in this case, as we wanted to use SW reset option as well as by toggling the I/O VDD and DVDD
Part Number: AM625 Other Parts Discussed in Thread: TAS2505 , Tool/software: Hello TI (EP),
We are using AM6254 with MCU SDK 9.0.
We want to port TAS2505 AMP and make audio output to SPK. ( we don't use HDMI).
May you guide and let us know how to solve…