Part Number: TAS2562 Tool/software: HI Ti engineer,
We currently have a requirement that the controller cannot call the functions in the snd_soc_dai_ops structure in the TS2562 driver, as shown in the following figure:
However, we can configure the…
Part Number: TAS2562 Tool/software: Hi,
I already install the software PPC3, can you help a ccess to TAS2562 EVM app?
My e-mail account: kent_su@sercomm.com
Thank you
Part Number: TAS2562 Tool/software: Hi expert,
Do we have Linux driver of TAS2562 can share to customer? I find some post mentioned Linux driver but inside is Android actually.
Regards,
Allan
Hi Gan,
That's correct, I described this wrong. 8Ohm connects 8Ohm resistor only. 4Ohm only connects 4Ohm. There's no case with both in series.
Please refer to this previous post, VBAT = 4V still has THDN <0.1%: (+) TAS2562YFPEVM-DC: PWM waveform…
Part Number: TAS2562
Dear Support,
For TAS2562 device, can I know if my bit clock is fixed at 3MHz and frame SYNC is 44.1Khz. Any requirement and rule to follow for bitclock in respect to FRAME SYNC?
Must it be sync?
Best regards,
kpk
Part Number: TAS2562
Dear Expert,
I would like to know the specifications about TAS2562 Please teach us about TAS2562 of Audio Amplifier.
We designed our equipment using TAS2562 for Audio spearker.
I have a speaker connected to the TAS2562 and am outputting…
Part Number: TAS2563 Other Parts Discussed in Thread: TAS2562 Hi team,
I believe the difference between TAS2562 and TAS2563 is that they have DSP or not, is that correct? Can I assume that all other parts of the device are equivalent?
Sincerely, Ryu
Part Number: TAS2562 Hi Team,
Recently we are trying to enable the Vbat limiter and BOP to prevent the prematurely shutting down in our battery powered applications.
One of our goal is keeping the voltage drop less than 200 mV when battery voltage is below…
Part Number: TAS2562 Other Parts Discussed in Thread: CC8530 , , , TAS2563 Hello,
One of our new products has a custom PCB using 2 TAS2562s and a CC8530. The chip gets stuck in a startup loop because the i2c bus is not working. I have included a scope capture…