Part Number: TAS2770 Hi Team I am able to get bitclock as 1.5Mhz and WS clock as 48KHz, properly. But still tas2770 is going to SW shutdown. Our requirement is to play < Signed 16 bit Little Endian, Rate 48000 Hz, Mono> Can you please say the i2c configurations…
Part Number: TAS2770 Other Parts Discussed in Thread: TAS2764 Hi team,
Could you pls help review the schematic for customer? thx
2 questions as below.
1. How to connect if PDMCK and PDMD are not used?
2. Customer reserved SDOUT output as SDIN…
Part Number: TAS2770 Other Parts Discussed in Thread: TAS2780 Team, we're designing an amplifier in a digital carrier board hosting Jetson GPU. The GPU offers an I2S interface for audio playback, and we prefer to choose the TAS2770 20-W as the amplifier…
Hi Sakthiyanandan,
I can confirm TAS2770 is not able to playback using PDM input, it is working only for recording purposes.
Let me check this with our design team and identify if there is a fix required for playback mode, or if we need to change…
Part Number: TAS2770
Hi,
We saw a glitch on the rising edge of IRQZ during TAS2770 power-up.
In our case, VBAT is enabled firstly and then enable 1.8V power for both AVDD and IOVDD. IRQZ is pulled up to same 1.8V power via a external 10k resistor…
Part Number: TAS2770EVM Other Parts Discussed in Thread: TAS2770 when I'm run the system in 44.1khz it works fine but when I'm try to run the system in 16khz it won't give any response in Speaker.
On though the detection of the sampling frequency(16khz…
Part Number: TAS2770 Hi,
i am using nxp imx 8M NANO board with TAS2770.my board is working on android OS. i want to set few register values of TAS2770 as per my requirement on boot up. i am using i2c_smbus_write_byte_data to set register values in tas2770…
Part Number: TAS2770 Hello, We have a TAS2770 audio amplifier connected to the I2s output of a Nordic Nrf52832 µC. But nothing on loudspeaker output (in green on the attached scope screen) I've configured the Nrf52 and can see I2S signal (yellow for FSYNC…
