Other Parts Discussed in Thread: TAS5414C-Q1 Hi, Team,
I have a question for TAS5414C-Q1.
What I want to know are bellows.
Is it OK to put 1uF cap on A_BYP and D_BYP? (I know it's not recommended by datasheet.)
-I guess the reason is related with…
Other Parts Discussed in Thread: TAS5414C-Q1 Hi,
Could you please tell us the behavior of the overvoltage protection ? The sequence of overvoltage protection is shown as below. We believe that the /FAULT pin is low, the output after the LC filter is Hi-Z…
Hi,
Could you please tell us the value(min/max) of the DC detect threshold ? We understand that the DC detect threshold which is mentioned on page 32 of data sheet as the typical value is 1.6V(default), the DC detect threshold tolerance which is mentioned…
Other Parts Discussed in Thread: TAS5414C-Q1 Hi,
Could you please give us your advice although we would like to grasp in detail about the short circuit protection which is mentioned on page 18 of TAS5414C-Q1 data sheet ?
Q1. Condition which SCP works …
Other Parts Discussed in Thread: TAS5414C-Q1 , TAS5414A Hi,
Could you please tell us how to transition this device into Hi-Z mode when detecting an OV, UV, OC, OT, or dc fault ? We understand that the first is the mute, the next step is low-low state, the…
Hi,
Could you please tell us the recovery procedure from the faults ? We understand that "Self-clearing" means that this device would automatically return if the cause of the error is cleared, "Latched" means that this device would return if the cause…
Other Parts Discussed in Thread: TAS5414C-Q1 Hi,
Could you please tell us whether TAS5414C-Q1 can detect the DC error as the following situations ?
Q1. Broken Half Bridge Could this device detect the dc error if a half bridge is broken only(other half bridge…
Hi,
Do the cycle-by-cycle current limit(CBC) and the overcurrent shutdown(OCSD) work in the low-low state properly ? Is our understanding correct although these protections do not work in this state ?
Best regards, Kato
Other Parts Discussed in Thread: TAS5414C-Q1 Hi,
We believe that although the frequency range depends on values of LC filter, we would like to confirm whether the high cut-off frequency is able to increase up to 40kHz. Could you please tell us your advice…
Other Parts Discussed in Thread: TAS5414C-Q1 , TAS5414B-Q1 Hi,
Although the PSRR is mentioned on page 8 of TAS5414C-Q1 data sheet, it is the value with 1kHz only. Then, could you please send us the frequency response of PSRR in the audio band(20Hz to 20kHz…
