Other Parts Discussed in Thread: TAS5706 , TAS5716 , TAS5825M , TAS5805M Hi,
I would like to design speaker array using TAS5716 or TAS5706.
Can I use these two products with I2S input and output with 4 channel?
Besides, I saw the TAS5716 and TAS5706…
Hi,
Is it possible to use Interchannel delay setting in these chips to generate delays of 150 us and 5 ms?
Please provide register settings for I2S audio sample rate of 48khz.
Thanks,
Goldy
I encountered this issue too. In document SLOU299, 12/2010, page 19 schematic, when I installed JP2 and JP3, the analog input frequency response was quite flat (down about 0.25dB @20KHz). However if I removed those jumpers to enable the 6dB input attenuation…
Other Parts Discussed in Thread: TAS5706 , TAS5760MD , TAS5754M Hi...
My customer is testing the Dynamic Range of TAS5706.
But I can not find the specification of dynamic range in the datasheet of TAS5706.
So I hope that you inform me of that. …
Other Parts Discussed in Thread: TAS5706 , TAS5706B Hi,
We were using TAS5706 in BTL mode.
Now We modified the speaker connection to SE 2.1 Mode and connect sub woofer.
But with new connection we are getting Noise at the beginning. It was not there…
Other Parts Discussed in Thread: TAS5706B , TAS5706 , TAS5754M Hi all!
Sorry if I'm double posting here but couldn't seem find a simple answer to this one while searching and a bit unsure about what the d/s really has to say in this subject.
In wonder…
Other Parts Discussed in Thread: TAS5706 , TAS5706B Hi,
How I verify that data is coming to TAS5706 is or not?
What care should be taken for chip initialization and clocking the chip?
How can we set TAS5706 as master codec?
Thanks,
Pa…
Other Parts Discussed in Thread: TAS5706 Hi,
Speaker output is working with TAS5706.
Now I want audio output on headphone. We have connected HPSEL pin GND.
In this case what register do i need to chagne?
I have enable HP mode by changing system…
Other Parts Discussed in Thread: TAS5706 Hi
I'm intending on using the subwoofer PWM output on the TAS5706 and I wanted to get suggestions on what low cost line driver and suggested filter setup I should use for the single ended analog output to a …
Hi David,
Sure, you can send the files via E2E messaging option.
Does the I2C script work well on the EVM setup? Is the thermal rise behavior seen on the EVM setup?
-Ravi
