Part Number: TAS5706B Other Parts Discussed in Thread: TAS5760MD , TAS5706
Hi Team, Do we have new solution like TAS5706B with headphone output? The headphone path need to from I2S and need to go through EQ and DRC. It is for echo cancellation. Do we…
Other Parts Discussed in Thread: TAS5706B , TAS5716 , TAS5756M , TAS5754M I've used both the TAS5706B and TAS5716 in the past with excellent results. Is one of them still the best choice today? I want audio fidelity specs equal to or better than the TAS5706B…
Hi Shital,
The RC filter connected to the TPA6110A2 from the TAS5706B is used to smooth out the PWM signal. This is usually recommended to be an RC filter with a corner frequency around 30k Hz, but can vary with different systems.
An example filter…
Hello Damien,
Thanks so much for a swift and good reply.
I (re-) checked all your points - and everything was (still) OK. But I noticed that the I2S data was fairly static. Turns out that the ADC in front was faulty. Again, very strange in a more…
Other Parts Discussed in Thread: TAS5706B , PCM1808 During product stand-by mode the TAS5706B is powered off by turning off supply voltages. Also during stand-by mode the AVDD (pin10) is exposed to periodic pulses caused by other parts in the design …
Other Parts Discussed in Thread: TAS5706B Hi,
Are there any recommendations as to how many KV TAS5706B can withstand? Our product will have ESD test conducted at the speaker terminal + rear panel (direct contact 4KV)
Do advise. Thank you.
Lee
Other Parts Discussed in Thread: TAS5706B Hey TI,
I would like to design a high quality stereo amplifier using the TAS5706B in 2.0 bridge mode, to drive 8 Ω loads .
For power supply I'm currently looking at the TPS7A4700 / TPS7A4701 because of its…
Other Parts Discussed in Thread: TAS5706B Good morning.
I'm using a TAS5706B in a dual mono configuration, so I have two IC for a stereo amplifier.
I use channel A and B in BTL mode.
First question:
can I miss to connect the components to channel…
Other Parts Discussed in Thread: TAS5706B , TAS5706 Is it possible to input a Stereo L and R signal into the TAS5706B and use the 7-Band EQ in PBTL mode? The signal needs to be summed within the chip as well.
If yes, then how?
