Part Number: TAS5715 Other Parts Discussed in Thread: TAS5825M Hello Support,
We have quite a stock of TAS5715 available ... We would like to use it as a slave with a 16Bit, 44,1KHz , Stereo I2S signal. Can the TAS5715 run without a MCLK singal ?
…
Part Number: TAS5715 Hi,
We are developing a speaker with TAS5715 amplifier chip, the noise will be much louder than allowed when no (audio) output.
I'd like to know that is there any methods to monitor/check the output? So i can mute on the software…
Part Number: TAS5715 Dear TI team:
Do you have register map description for TAS5715?
I can't find any related file on line.
Also for the GDE, do you have more file to explain what is scal etc, for some tuning module, we can't understand it. thanks…
Part Number: TAS5715 Dear TI team,
Thanks for taking time to read my post.
We designed a speaker with TAS5715 PHPR chip and followed the guidance of user manual.
But we find the output level of each board are different, some higher and some lower…
Part Number: TAS5715 Please inquire about TAS 5715 digital amplifier.
We are trying to adjust and get Bass / treble according to the set production style and the condition of the speaker
I can not find a definite register setting method ...
Bass…
Part Number: TAS5715 The customer is using TAS5715 (2pcs on a board), PBTL, AD mode.
During the pilot production, some issues have been found.
During the initiation status, pop issue would occur on some boards.
The customer found pop occurred at…
Hi Christopher,
The TAS5715 device produces a differential output, so the problem I see is that the out+ and out- pins are being shorted together and the "bridge" output is referenced to ground.
In BTL mode the device can drive 2 speakers (differential…
Part Number: TAS5715EVM Other Parts Discussed in Thread: TAS5715 , TAS5713 When we use TAS5715 EVM board to tone, It is found that if the L channel is tuned to treble with BQ3, If you turn R channel into bass with BQ4 After tuning up, the sound of L channel…
Part Number: TAS5715
Hi,
What is the maximum possible output power to a 4E 40W speaker using this configuration? Is there any registers' dependency to get maximum output?
