Part Number: TAS5751M Tool/software: Hello,
We plan to develop Mono input Low frequency SPK out and High frequency SPK out configuration amplifier system instead of LC filtering 2way speaker system.
In this case how can we utilize PPC3 default 3band…
Part Number: TAS5751M
Hi, I'm using TAS5751M chip to build an amplifier with 24V supply, BD modulation, PBTL mode, 4 ohm load, and tested the max power 53W,there's no over-temperature or over-current protection, but the power won't go back up.The diagram…
Part Number: TAS5751M Other Parts Discussed in Thread: TAS5805M Hi team,
My customer use the TAS5751M and need to find a better way to cool the part in a sealed chamber on the product. They are considering adding a heat sink but not sure if that will…
Part Number: TAS5751M Hi team
My customer requested the software access permission of TAS5751 in ppc3, the account is jiye.xu@lango-tech.cn please give the approval for this request, thank you!
One more question: why sometimes I login PPC 3, there…
Part Number: TAS5751M Other Parts Discussed in Thread: TAS5733L Hi All,
I have a question on the TAS5751M.
What is the PVDD value for the protection characteristics conditions? Also, the IOC current value seems to be low.Is the value correct?
…
Part Number: TAS5751M Other Parts Discussed in Thread: TAS5805M , TAS5825M Hi, TI support team
I am trying to configure a 2.1ch speaker AMP.
The prerequisites for configuration are as follows.
- 2.1ch Audio out
- 20W per channel
- EQ setting…
Part Number: TAS5751M Section 7.6.1.2 indicates that a resistor should be used to pull pin 19 high or low. See page 24 of https://www.ti.com/lit/ds/symlink/tas5751m.pdf?ts=1681193555723 .
The EVM shows this on pages 21-23 of https://www.ti.com/lit/ug…
Part Number: TAS5751M Hi Team,
TAS5751 ADR/FAULT pin not stable, have Low-level output voltage,
what possible problems will there be? Please refer to attachment AMIS-M-SCH_DAMP-DB1-V10_1130, board fil: AMIS-M-DAMP-V1-2022-1130-FINAL and SYSTEM BLK…
Part Number: TAS5825M Other Parts Discussed in Thread: TAS5751M Hello, I use the TAS5751M chip in accordance with the EVM board amplifier, distortion and signal-to-noise ratio is normal, but only the frequency response attenuation is too large, the first…
