Part Number: TAS5760L Tool/software: I would like to know the dB-expressed gain of the TAS5760L converted into dBV. ・Digital Boost ・Volume Control ・Digital Clipper Regards, Ishibashi
Part Number: TAS5760L Other Parts Discussed in Thread: TAS5760M Dear Team,
We are facing that cannot set control port resisters collentIy. So, I have some question about I2C as below.
#1 If Master write some parameter in state "SPK_SD=H", are there…
Part Number: TAS5760L Dear Team,
I have a question about Soft Clipper of TAS5760L. Is the behavior of set "Resistor to GVDD" to (Open), same as set "Resistor to GVDD" to 0Ω? I'd like to ask wheather I can disactivate the use of Soft Clipper or not.…
Part Number: TAS5760L Hi All,
I am using ESP32 in a prototype, along with the TI TAS5760L. The I2C bus is working and I can read and write to the registers.
Presently, I get the following outputs from the registers:
Register Values Amplifier Disabled…
Part Number: TAS5760L We are using an TAS5760L with MCLK connected to SCLK and ratio of SCLK/LRCK 64. But we get no audio at all. I found a post from 2017 where this very issue is addressed, but the datasheet still says it should support 64x. I'm a little…
Part Number: TAS5760L Other Parts Discussed in Thread: TAS5760M Dear Sirs,
My customer asked us about output voltage level of TAS5760L at THD+N≦0.8%. When he checked on his prototype board, the output voltage was 6.8 Vrms (7.9 W). So he was asked whether…
Part Number: TAS5760L Other Parts Discussed in Thread: TAS5760M , , TPA3116D2 , TAS5760XXEVM Dear Sirs,
My customer asked us about EMI data for TAS5760L and TAS5760M.
Could you please let me know EMI data.
Best Regards,
Y.Hasebe
Part Number: TAS5760L Dear Sirs,
My customer asked us about Output Level vs VDD of PBTL mode for TAS5760M & TAS5760L
my customer knows that RL = 6 Ω, THD + N = 10% data in the data sheet.
However, he needs data under the following conditions.…
