Search tips
Showing 600 results View by: Thread Post Sort by
    Answered

  • TAS5825M: Time order of TAS5825 apply in customer system

    Resolved
    Part Number: TAS5825M Other Parts Discussed in Thread: TAS5805 Hi team TAS5825 is used in array microphone system by customer, the amplifier is used to playback the voice which collected by an ADC. In the system design, there is no data buffer for ADC…
    • Resolved

  • TAS5825M: Application issues

    TI Thinks Resolved
    Part Number: TAS5825M Other Parts Discussed in Thread: TAS5805 Hi, Can you provide a driver file for the Android version? The kernel version is 5.15.41

  • TAS5825M: pcb layer stack recommendations

    TI Thinks Resolved
    Part Number: TAS5825M I have a design with a three tas5825m with one as a PDTL sub. Currently, the design is a 4 layer board with an internal ground plane. Does anyone have any recommendations on the copper weights for all layers and the hole size for…

  • TAS5825M: Hearable noise from TAS5825M output

    Part Number: TAS5825M Hi, In our product, the TAS5825M receives I2S signal from a wireless audio module, the sample rate of the input I2S is 46.87KHz. When the audio source stops play, the I2S carries a low noise, the level is approximately -90dBFS…

  • TAS5825M: Configuration file has gone corrupt.

    TI Thinks Resolved
    Part Number: TAS5825M Hi, I was working in Pure Path 3, saved my file and then a couple hours later tried to reopen the file and I received this message. "The selected PPC3 file is created with the Process-Flow which is not supported by the current versions…

  • TAS5825MEVM-SB: TAS5825M speaker characterization using learning board

    TI Thinks Resolved
    Part Number: TAS5825MEVM-SB Other Parts Discussed in Thread: TAS5825M Hello, I am trying to measure speaker thermal properties for use in the TAS5825M. I have several questions: 1. Can I measure thermal properties using PPC3, PPCEVM, and TAS5825M-EVM…

  • RE: TAS5825M: Overcurrent / DC-Fault problems

    hi Diederik the AGL you don't want to use, is that because you don't want the tas5825m configuration affect the tas5825p output? if yes, i think you can config as below which will make sdout output the data haven't been processed by DSP. …
    • Answered

  • TAS5825MEVM: TAS5825M configuration on PPC3

    Resolved
    Part Number: TAS5825MEVM Other Parts Discussed in Thread: TAS5825M Hello, Ever since our customer tried to evaluate TAS5825M with PPC3, he confused how he can control via PPC3. he could not find out TAS5825M contents as shown in below. Could you tell him…
    • Resolved
    • Answered

  • TAS5825M: Peak 100W possible by 1ch PBTL

    Resolved
    Part Number: TAS5825M Other Parts Discussed in Thread: TAS5828M Hi experts, My customer wants to know how many power can TAS5825 get out. Is it possible to get 100W following conditions; Out: 1ch PBTL Imp: 3~4 Ohm THD: Roughly 30% Regards, Youhei MI…
    • Resolved

  • RE: TAS5825M: TAS5751M amplifier frequency response attenuation is too large

    Hi Found, Please give the waveform of OUTPUT when power exceeds 42W. I want to observe whether it is clipped. FOUND HUANG said: why my amplifier can only reach a maximum power of about 42W,

Didn't find what you are looking for? Post a new question.