Part Number: TAS5825P Tool/software: Dear expert:
At 100HZ/25W in the first few batches, a certain number of THD parameters measured will be too large, THD value> 2%,and the issue number proportion is greater than 0.73%. total sum is 17980
Part Number: TAS5825P Tool/software: Hi,
May I ask under what conditions the TAS5825P will enter "sleep mode"? There is no relevant information in the datasheet. Only mentions compare with Shutdown Mode (Pull PDN Low), enter or exit Sleep Mode, DSP…
Part Number: TAS5825P Other Parts Discussed in Thread: TAS5825M ,
Tool/software:
Hello, There are some differences in setting resistor.(Between TAS5825M and TAS5825P) For example, TAS5825M has SAP_CTRL3 register(35h), and TAS5825P doesn't have.
…
Part Number: TAS5825P Other Parts Discussed in Thread: TAS5827 Hi TI team,
What is the maximum TDM channel for TAS5825P?
We are using 3 pcs TAS5825P and 1pcs TAS5827 amplifier in our speaker system.
We want to use TDM8 output from DSP to AMPS througn…
Part Number: TAS5825P Hello,
We are planning to use the TAS5825P/M IC for a smart speaker. The design has one speaker permanently connected to one channel of the amplifier. The other channel may or may not have a speaker attached according to customer…
Part Number: TAS5825P Tool/software: Hello,
While our customer verifies TAS5825P, he found out SRC frequency characteristics was different from 44.1kHz fs and 48kHz fs input case, and it seems like SRC paramters are not automatically adjusting depending…
Part Number: TAS5825P Tool/software: Hi ti team，
The new project is using the TAS5525P and is currently in the schematic phase.
The 10-pin of TAS5828P is set to MUTE, and the 11-pin of TAS5825P is set to BOOST FB detection pin. Is this setting correct…
Part Number: TAS5825P Tool/software: Hi ti team，
The customer is using 1SPW Modulation and found that the THD is too large. The datasheet only has THD curves for Hybrid Modulation and BD. Please provide THD curves for 1SPW Modulation.
PVDD=16.4V Load…
Part Number: TAS5825P Tool/software: Hi BU expert,
When I test the TAS5825P, I have found that the result is level meter is input level from AP minus -3.9dB, do you know what happen? I mean when I set the input signal is -3dB, the level meter result…
Part Number: TAS5825P
Hi:)
-
According to the "TAS5825P Hybrid-Pro User Guidance", when there are several TAS5825P ICs with the Hybrid-Pro feature enabled the Hybrid-Pro outputs should be set to 'Open-Drain' and connected together, along with a…
