Part Number: TAS6424E-Q1 Other Parts Discussed in Thread: TAS6422E-Q1 Hi team,
We found some STBY Current parameter issure from datasheet.
The customer found that the STBY current of the TAS6424E-Q1 is even lower than that of the TAS6422E-Q1. Why…
Part Number: TAS6422E-Q1 Other Parts Discussed in Thread: TAS6422EQ1EVM Hello,
We're developing a car speaker audio system using the TAS6422E-Q1. To this end, we purchased and are evaluating the TAS6422EQ1EVM.
We'd like to reference the PCB design…
Hi
user5184363 said: So, if it means we can not use the one of minimum value 3.3uH when pwm frequency is selected 384KHz?
There would be very large ripple current on the inductor, lead to very large idle loss.
user5184363 said: What inductor value…
Part Number: TAS6422-Q1 Tool/software: I am writing to request some additional information regarding the TAS6422-Q1 audio amplifier IC that is not available in the current datasheet.
We are considering using this IC in an upcoming project and need some…
Part Number: TAS6422-Q1 Tool/software: Dear TI experts,
My customer have a question about the conditions of each fault situations. Could you check it?
1. Short to GND
2. Short to battery
3. Open load
4. Shorted load
(for example, the impedance…
Other Parts Discussed in Thread: TAS6422-Q1
Hi, Support Team
Q1: if TAS6422-Q1 output disconnect to speaker, the TAS6422-Q1 have alert is trigger from FAULT pin?
Q2: under voltage/over voltage trigger is from FAULT pin?
note: our client verify…
Part Number: TAS6422-Q1 Tool/software: Hello,
we have the problem, that in the field on several devices a short to power is detected on channel 1 and 2. In the lab we haven't been able to reproduce it. It could be suspicious that the state control 0x04…
Part Number: TAS6422E-Q1 Other Parts Discussed in Thread: TAS6422-Q1 Tool/software: Hi Team,
We are using the TAS6422QDKQRQ1 in our design for the product.
Following are the Amplifier configuration done through I2C 1. Mode Control Register 0x00 =…
