Part Number: TAS6511-Q1 Other Parts Discussed in Thread: TAS5830 We have checked the latest datasheet TAS6511,
But unfortunately, I see it is not well define for package.
I cannot see pinout VQFN24pins and Figure VQFN24 symbol is not too.
I cannot…
Part Number: TAS6511-Q1
What is the mapping of the TEMP SENSOR Register to Temp in Celcius? On our TAS6511, when I use the equation "Bit value*2.93-273.15" in the datasheet, the conversion gives me 186 degrees Celcius when the Channel is running no…
Part Number: TAS6511-Q1 Hi Expert:
I would like to understand how much response times is need of the Fault pin trigger low when the output fault triggered ? ( if Output short to GND or speaker short together )
thank you
Roy
Part Number: TAS6511-Q1 Tool/software: Hello Application Team:
We would like to use TAS6511-Q1 Real time load diagnostic feature to monitor speaker output impedance. regarding datasheet the 6511 can generate internal pilot tone -> default 6Hz, -36dbfs…
Part Number: TAS6511-Q1 Hi Ti
When I use TAS6511 play sound in TDM mode , it out hiss noise
But When I use I2S mode , it out sound is ok
there is my TDM configure
0x21 0x04 //set TDM mode
0x23 0x00 //set 16 bits
0x33 0x00 //set slot 1
Why…
Hi
pengfei sui said: firstly , I i2ctransfer -f -y 3 w2@0x59 0x40 0x39
Sorry, I can't understand it. Could you please be more specific, which register, and what value you write into?
pengfei sui said: set STATE_CTRL Register 0x40 value =0x39
Should…
Part Number: TAS6511-Q1 Other Parts Discussed in Thread: TAS6424-Q1 ,
Hi team,
I want to ask a question following up on this thread.
(+) TAS6584-Q1: DSP Mode vs. TDM Mode - Audio forum - Audio - TI E2E support forums ,
Why TAS6511-Q1 and TAS6424…
Hi Yogesh
Yogesh Khairnar said: Up to what burst duration can the amplifier support its output power rating?
Usually when doing burst test to check max power, will have several sinewave cycle, able to capture the max power is enough.
Yogesh Khairnar…
