Search tips
Showing 31 results View by: Thread Post Sort by
    Answered

  • RE: THS4032: Non Inverting Op-Amp Output Connected to Additional Supply

    Resolved
    Hi Mohd, Apologies for the delay. With the input floating, then the THS4032 will probably rail to either supply. This will cause a problem when the output voltage is different from V3, as the two voltages will compete and potentially cause sufficient…
    • Answered

  • THS4032: Data sheet stencil thickness recommendation correct?

    Resolved
    Part Number: THS4032 We've been unable to get a good solder joint on the ground surface of this component. It looks like the leads are holding the ground surface up above the surface of the PCB, so the solder has to bridge that gap. When I reviewed…
    • Resolved
    • Answered

  • THS4032: Single Ended Multiple Feedback Amplifier Design

    Resolved
    Part Number: THS4032 Other Parts Discussed in Thread: OPA2209 I am in the process of designing Single Ended Multiple Feedback amplifier for band pass filter. The center frequency of the 4th order band pass filter is 1MHz (should operate between 500KHz…
    • Resolved
    • Answered

  • RE: LMP7718: Max possible gain for a 100khz sinewave input ?

    Resolved
    Hi Ishan, Our tool cross reference tool suggests the THS4032 as a potential replacement for the LT device, however the minimum supply requirement is 9V. In simulation, the device does not suggest any potential failure points and certainly does not show…
    • Answered

  • Competitor information (THS4032, THS4130)

    Resolved
    Other Parts Discussed in Thread: THS4130 , THS4032 Hi, I would like to ask you to give me the competitor information of THS4032 and THS4130. Could you tell me the information? Best Regards,
    • Resolved

  • [FAQ] [H] High-Speed Amplifiers Other Amplifier Circuits

    Frequently Asked Questions: Amplifiers >> High Speed Amplifiers >> Other Op Amp Circuits Circuit Design Considerations Transimpedance Amplifier Circuits Fully Differential Amplifier Circuits ADC Driver Circuits Other Op Amp Circuits St…
    • Answered

  • THS4012: Problem with working temperature

    Resolved
    Part Number: THS4012 Other Parts Discussed in Thread: THS4032 , OPA2690 , OPA2691 , THS4011 , TINA-TI , OPA690 Hi Team, I have created an 4 channel double isolation for analog video signal (CVBS). After optoisolation I have a video signal 1Vp-p with 9V off…
    • Resolved
    • Answered

  • RE: OPA564: How to simulate stability of Howland current source using opa564

    Resolved
    OK, The output sine wave seems stable for now based on measured waveform,so I can wait, no hurry. I also notcied you replied on another post of mine related to THS4032, thank you again for helping.
    • Answered

  • RE: THS4042: Can THS4042 drive 0.1uF output capacitance with Figure 68. Noninverting, Unity Gain Schematic on page 17?

    Resolved
    Hello Kazuya, Have you considered using a current feedback amplifier? The amplifiers typically provide higher output current and slew rates, making them especially suitable for driving large capactivie loads. Some suggestions you should look at are the…

  • Microvolt Signal Amplification at 1 MHz frequency

    TI Thinks Resolved
    Other Parts Discussed in Thread: THS4032 Hi, I have gone through the previous posts regarding microvolt measurement , such as ( https://e2e.ti.com/support/amplifiers/precision_amplifiers/f/14/t/293906

Didn't find what you are looking for? Post a new question.