Other Parts Discussed in Thread: TIDA-00195 Hi,
1. TIDA-00195 is supplied from dc source. I want to use 3 phase 400VAC via bridge rectifier.
2. Can I use this equation for keeping bus ripple voltage under specific percentage?
Eg.
VbusRipple= I(bus) /…
Part Number: TIDA-00195 Other Parts Discussed in Thread: TIDA-010025 , TIDA-00914 Hello TI Experts,
With reference to this evaluation board:
https://www.ti.com/tool/TIDA-00195
Could you kindly clarify how are the motor currents measured and sent to the…
Part Number: TIDA-00195 What will be the parameter of user.h in Instaspin library for TIDA-00195 Board
correct parameters based on the hardware board in user.h
#define USER_IQ_FULL_SCALE_VOLTAGE_V (xx)
#define USER_VOLTAGE_FILTER_POLE_Hz (xx)
#define…
Hello Dave,
I am following up the old thread. I apologize for late feedback.
Typically the current written on a AC induction motor's name plate is the current per phase . You will see that phase nominal current when the AC induction motor runs at the…
Part Number: TIDA-00195
hi everyone
good day!
in TIDA-00195 the parallel Capacitor in GE (C142,C71,C55,C38,C153,C164) are used to reduce the amount of inducted voltage at the bottom IGBT.
the question that comes to my mind is that using parallel capacitor…
Hi Dino,
Thanks for your feedback. I made a typo, sorry. The correct number is TIDA-00195: https://www.ti.com/tool/TIDA-00195
Regarding LAUNCHXL-F28027 Development kit. The MCU and software was not part of the TUEV assessment. Please refer to the TIDA-01599…
Part Number: TIDA-00195 Dear sir,
Snubber capacitor was used in TIDA-00195.
In this design, C154 is used as snubber capacitor for this IGBT module.
Could you please confirm the same.
Thanks & regards,
Rajasekaran.
Part Number: ISO5852S Other Parts Discussed in Thread: TIDA-00195 Dear sir,
We wish to design the inverter using ISO5852S similar to TIDA-00195.
In this model, all the six FLT signals are connected together and using one 10kOhm pull-up resistor.
Kindly…
Part Number: TIDA-00195
Hi ,
In the application Note, It is mentioned that 50% duty ratio and 500khz signal needs to be used for half-bridge power supply. I would like to know the dead time value that you have used in this application note. Thanks in…
Part Number: TIDA-00195 Other Parts Discussed in Thread: UCC21732-Q1 We found layout problem on the TIDA-00195.
In the layout, it places a ground plan which is connected to GND2 for sensitive signal layer on high side IGBT gate driver.
My question is…
