Part Number: TIDA-00851-LDC0851 Other Parts Discussed in Thread: LDC0851 , LDC1612EVM , BOOST-LDC3114EVM , TIDA-00508 Hello Team,
I have gone through LDC0851 user guide , in that you have mention that only 32 position it can detect, can you elobrate…
Part Number: TIDA-00851-LDC0851 Other Parts Discussed in Thread: LDC0851 Dear sir,
I am planning to replace traditional proximity sensor discrete circuit with the chip LDC0851.
For coil design the recommended thickness for the PCB as well as copper…
Other Parts Discussed in Thread: TIDA-00851 , PGA900 I build the board based on TIDA-00851 design to measure RTD and testing it using PGA900EVM board. I am following all steps from the design guide but I am getting the negative voltage readings.
The…
Part Number: PGA900 Other Parts Discussed in Thread: TIDA-00851 ,
hello I am coding firmware using the TIDA-00851 board. I am contacting you because I have a problem with UART communication.
The version of CCS is 12.1.0.00007.
And the TIDA-00851…
Hello Yuhao,
This could be achieved with the LDC0851. Please see the reference design below. It is important to note that this design does not determine rotation direction(CW or CCW). In order to determine direction, you would need to have a 2nd LDC0851…
Ivano,
That makes sense for simplicity.
To determine direction, you would place the two sensors next to each other so that the rotating target goes over both sensors individually. With this setup, in clockwise direction, you would see one sensor 1…
Part Number: PGA900 Other Parts Discussed in Thread: UNIFLASH , TIDA-00851 I am using the TIDA00851 board. If you compile the provided example code using CCS and debug by connecting the XDS200, the code will operate normally. If you disconnect XDS, it…
There is a variety of information that can be found on E2E regarding these devices. You can submit a search for information, or you can click on the various links below to get started:
General PGA device overview
Questions specific to the PGA900…
Part Number: PGA900EVM Other Parts Discussed in Thread: TIDA-00851 Tool/software: Code Composer Studio Hi good day. I am trying to program the PGA900EVM board with the example TIDA 00851 firmware, I got it to compile, I followed the configuration steps…
Hello All,
The construction shown above will not work. The LDC sensor needs to have an unobstructed view towards the rotating metal. If you have other metal between the sensor and the moving target, the LDC will be unable to sense this. If there is…
