Part Number: TIDA-010081 Other Parts Discussed in Thread: UCC28180 Hi
I am using UCC28180 IC for Front end PFC section for EV charger,Power rating is 1KW.
Everything works well but sometimes while turn on AC 230V, Inrush and PFC FET blown ,completely…
Part Number: TIDA-010081 Other Parts Discussed in Thread: TIDA-010015 Hi,
the linked thread mentions/implies the use of TIDA-010081 reference design for a 24V output.
Has anybody tried this?
I've looked at TIDA-010015 & TIDA-010081 - which design would…
Part Number: TIDA-010081 Other Parts Discussed in Thread: UCC28180 Hi ti expert,
Good evening
I am using UCC28180 PFC IC for 1kW EV charger front end.
I have tested PFC circuit alone using Rheostat load(2 nos of Board), switching frequency is 100KHZ.output…
Part Number: TIDA-010081 Hi,
I would like to use this LLC IC for EV charger.(LLC Half bridge topology)
Requirement is 1KW, 0 to 59V,0 to 17A
But actual output voltage and current must be controlled via CAN communication.for this i am using STM32G0 IC…
Part Number: TIDA-010081
TIDA-010080 reference design
How to calculate L5 inductor values,we require current ripple about 2% of Load current 20A.
advise me how to calculate L value here please
Thank you,
venkatesh B
thanks in advance
Part Number: TIDA-010081 Hi,
In this output side(secondary transformer),output voltage polarity comes negative if we consider dot polarity as per Reference design.
Kindly clarify my doubt, whether my assumption is wrong or reference design it is rev…
Part Number: UCC28180
Hi,
i am using UCC28180 IC for PFC operation,1KW power
Under No load PFC Voltage maintained at 415V as set,under minimum load PF is 94,while increasing Loading PF getting reduced and Current is distorted like this(attached image…
Part Number: UCC28180 Other Parts Discussed in Thread: TL431 , UCC28064A , UCC28050 , UCC2818 , UCC28056 , UCC28065 , UCC28070A Hi ,
I have implemened 1kW PFC stage as AC to DC with PFC Operation and its working good.
in my output 100HZ ripple component comes…
Part Number: TIDA-010081 Dear TI team,
we have used this LLC reference design, for Battery charger but Transformer is getting too HOT when load current increases beyond 10A.
Temperature gradually increasing exponentially at low Current say output 10A…
Part Number: TIDA-010081 Other Parts Discussed in Thread: TIDA-010080 good morning,
In 1KW Ref design, output side Resistor (DNP as shown) is required or not.
for us output voltage shoots to 80V.our set point is 61V only.we have not populated this Resistor…