Part Number: LM5030 Other Parts Discussed in Thread: TIDA-01352 Hi,
We got a question from the customer about LM5030. Could you help us?
[Question] They are considering using LM5030 based on TIDA-01352 at 14V input voltage. Thus they have to change some…
Part Number: TIDA-01352 Other Parts Discussed in Thread: LM5030 , TINA-TI
Hi,
Do anyone have TINA simulation files of any one of the following sections of TIDA-01352?
1.Positive HV Push Pull Power Supply section 2.Positive LV Push Pull Power Supply se…
Part Number: LM5030 Other Parts Discussed in Thread: TIDA-01352 Dear mr.
My questions:
1. I try to build power supply 400W, Vin=18V-29V to 300V with LM5030 and order for it planar transformer with next parameters: 500W, n=1:19, Lprimary1-3= 8.5uH (10kHz…
Hi,
As your input voltage minimum is 8.5V compared to TIDA-01352 24V, the transformer turns ratio for TIDA-01352 Np:21Ns = 1:7.5, then yours should be Np:Ns = 1:(7.5 x 24/8.5) = 1: 21.2. Other parameters can be similar to TIDA-01352 transformer 750343547…
Hello Hunting,
Have you look at TIDA-01352? It can support up to 100W on each rail and uses LM5030 in push-pull configuration.
Regards,
Sanjay R. Pithadia
Other Parts Discussed in Thread: TIDA-01352 , LM5030 , TIDA-01592 , LM3481 , TIDA-010057 , LM3488 , LM3524D
I have referred following documents so please find my query/comments as under.
TIDA-01352
>> This board is based on LM5030 with push pull to…
Part Number: TIDA-01371 Other Parts Discussed in Thread: TIDA-01352 I would like to obtain the circuit for the SMPS mentioned in this TIDA-01371 document, thanks.
Hi Jason,
Sorry for the delay in replying.
We have two TI Design for transmit power supply: TIDA-01352 and TIDA-01371. The TIDA-01352 is the SMPS for generating +/- voltage rails for the tranmit power supply. TIDA-01371 is floating regulator design for…
Hello Fukazawa,
With this limited information, I would suggest TIDA - 01352 is a good choice of a power supply with scalable output and high efficiency with LM5030 integrated.
Section 2.3.2 talks in great lengths about designing the push-pull power supply…
Hi Scott,
Can I use the output stage of this reférence ( www.ti.com/.../TIDA-01352)design to get an output of 150 volts ?
If it's possible to use it, which IC can replace the lm5030 to allow me to drive the output with the tdc tx pin?
