Hi cem
The assembly drawing of the DLPDLCR2000EVM is available on it's reference design page here: www.ti.com/.../tida-01473
Can you see whether this is sufficient for your requirements?
Regards
Azad
Hello Cecile,
You can find the Bill of Materials (BOM) and schematic for the DLP2000 EVM at www.ti.com/.../tida-01473 . The power supply (J2) is a CONN POWERJACK 2.1mm.
Thanks,
Kyle
Hi Shai,
Please use the following refrence design for DLPC2607 www.ti.com/.../tida-01473
This reference design is based on DLP2000 EVM . You have to make changes for smaller footprint.
regards,
Vivek
Lance,
Welcome to the E2E forums, and thanks for your interest in our DLP technology.
You have the right idea here regarding the PIC. As long as you are supplying the parallel video data lines, Vsync, Hsync, Pclk, and the I2C lines you don't need…
Mark,
There is a voltage monitor within the system which will prevent the system from turning on (or perhaps shut the system off mid-operation). You can see it in the reference design associated with this EVM:
www.ti.com/.../tida-01473
www.ti.com…
You may need to check our TI Design Network partners page for information on contacts.
Mechanical components are all listed in the mechanical BOM, which can be found in the DLP2000EVM reference design :
www.ti.com/.../tida-01473
I hope this helps…
Philbert,
You may be looking at the trace length that this particular EVM uses in the design. While I don't have that data on hand, you should be able to measure it by looking at the PCB layout file included with the DLPDLCR2000EVM TI Design. You can…
Josh,
Thanks for your interest in our DLP products, and welcome to the E2E forums.
Outside of the assembly drawings available on our TI Design page, I do not believe we offer 3d model files for the DLPDLCR2000EVM at this time. I apologize for the…
