Other Parts Discussed in Thread: TMDSCNCD28379D , TIDM-1000 , SYSCONFIG Hi,
I want to use TIDM-1000 "pfc3phvienna_F2837x" code on "TMDSCNCD28379D", I launch main.syscfg, all rectifier parameters such as inductance values, RC sense filter values,…
Part Number: TIDM-1000 Tool/software: Hi,
I'm working with the TIDM-1000 which is working fine at the default switching frequency of 50kHz. I'm trying to increase the switching frequency, and my goal is to increase the PWM frequency without changing…
Part Number: TIDM-1000 Other Parts Discussed in Thread: POWERSUITE , C2000WARE Tool/software: Hello,
For debugging purpose, I would like to use DAC that are available on TIDM-1000 PFC evaluation board, on connector J5 :
In PowerSuite SW I think that…
Part Number: TIDM-1000 Tool/software: Hi Team,
Can TIDM-1000 support no load output? The user guide indicates need 500R to do the test.
But customers do not need the 500R. They think this condition does not make sense.
So how to modify the FW to achieve…
Part Number: TIDM-1000 Tool/software: Hello,
On TIDM-1000 PFC Vienna evaluation board, I don't understand why it is necessary to connect power supply neutral to DC bus mid-point when working in open loop.
Could you explain a little bit ?
Thank you…
Part Number: TIDM-1000 Other Parts Discussed in Thread: SFRA Tool/software: Hello, I started using TIDM1000 PFC Eval Board with Power Suite tooling. I went through INCR_BUILDS 1 to 4 but I have an issue with current quality.
My set-up is : Use of power suite…
Part Number: TIDM-1000 Other Parts Discussed in Thread: TMDSCNCD28379D ,
Tool/software:
Hi,
I am working with TIDM-1000 board using the control board TMDSCNCD28379D, when I am starting with BUILD1 configuration, getting the output as shown below. I didn…
Hello,
1. Is this seen at start-up?
2. is this happening while doing a closed loop/open loop? Good to confirm if open loop is seeing such inrush currents or not?
3. Can you check on the NTC as mentioned by Chen on this E2E, https://e2e.ti.com/support/microcontrollers…
Part Number: TIDM-1000 Hi all,
Are the parts used in the TIDM-1000 reference design completely consistent with the BOM?
According to the reference design, the efficiency can reach 98% under 208Vrms,L-L voltage testing. But our actual measurement result…
Part Number: TIDM-1000 Hi Team,
I'm asking for my customer:
Does the input current of the Vienna rectifier vary depending on the load? What is the current range in a rectifier bridge? Can the peak current reach 10A? What is the current range on the…
