Other Parts Discussed in Thread: LMR43610 , LM5143 Dear Team,
We are looking for a DC-DC buck converter for the TCU and actuator motor application.
Could you please provide us with the contact details of the relevant team for support?
Regards…
Hi Nick,
It's no problem at all. In general, we are not allowed to share the internal schematics of chips.
Regarding the feedback reference voltage, yes, you are correct in referring to the reference voltage in the error amplifier. The reference voltage…
Part Number: TPSM64406 Tool/software: Hello dear TI Team,
I'd like to use TPSM64406 chip but I don't need as much as 6A current for my particular application.
Is it possible to use the chip in dual mode (config resistor either 0 or 120k) and tie the…
Part Number: UCC28C40 Other Parts Discussed in Thread: UCC28951 , UCC256403 , Tool/software: Input DC : 300V to 1500V
Output Voltage : 22V DC
Output power: 500W
Compact and low cost design.
Part Number: TPS65131 Other Parts Discussed in Thread: PGA855 , INA823 , PGA855EVM Tool/software: Hi Patrick,
I apologize for reviving the old post now ( TPS65131: Noise issue on dual DC/DC converter ). I measured the current across resistors R118 for…
Part Number: UCC28251 Other Parts Discussed in Thread: LM25037 Tool/software: Hello Team,
I am planning to use UCC28251 for our application with below requirements:
Topology: Full Bridge (Hard switched)
Input: 660V (Fixed)
Output: 54V
Output…
Part Number: UC3827-1 Other Parts Discussed in Thread: UC2827-1 Tool/software: Hi, my question is related to the feedback loop, we have two stage conversion buck followed by pushpull. the control signal is fed the Buck switch but the sensed voltage is…
Part Number: UCC33420-Q1 Other Parts Discussed in Thread: UCC33020-Q1 Tool/software: Hello TI team,
We are currently developing an ECU module, where the hardware needs a 5V to 5V DC DC auto grade isolated converter. We have identified two parts of TI…
Part Number: TPS65131 Tool/software: Hi everyone!
I used the TPS65131 in my project to have a dual power supply following the application notes and the routing of the evaluation board. When I power the board I hear an annoying buzz . I checked the schematic…
