Part Number: TL432-Q1 Other Parts Discussed in Thread: TL432 , Tool/software:
Part Number: TL432A-Q1
Dear Texas Instruments Team,
Urgent information required on how reference voltage, cathode voltage and cathode current was adjusting based on inputs for …
Part Number: TL432 Our team is currently using TL432 for a product that utilizes current source. TL432 in this case has been used for both as an amplifier and a current shunt. When conducting conductive immunity (10Vrms) testing, we noticed that the Vref…
Part Number: TL432 Hi,
I have a POE supply design based on the evalboard . The TL432 is used in the feedback loop of the converter.
NCP1083QBCGEVB_SCHEMATIC.PDF
The design seemed fine until I noticed some drifting in the outpout voltage of the converter…
Part Number: TL432 Other Parts Discussed in Thread: TLVH432
Hello.
I hope you understand my lack of English. We are using TL432 for OCP circuits. As shown in the picture below, there is an oscillation phenomenon for some TL432 samples with the corresponding…
Part Number: TL432 You mentioned that "load capacitance greater than 10uF or smaller than 0.01uF," however, the below figure shows the lowest capacitance is 0.001uF.
Is 0uF acceptable?
Part Number: TL432 Other Parts Discussed in Thread: TLVH432 Hi
My customer used TL432 and op-amp to construct the OCP circuit. However, there have been many defects recently. At first, They thought it was a defective part. But they want to check if the circuit…
Part Number: TL432 Hi team,
Is there an absolute maximum rating for the reference voltage? I would like to know if there is a maximum rating for the voltage range.
Sincerely. Ryu
Part Number: TL432 Hi Team,
Our customer is looking for a replacement to TL432AIPK since it has limited stocks now. Aside from the differences in the accuracy and temperature ratings of the devices, he would like to know the following information.
1. What…